MRA Aprilia Tuono 660 2021 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
4 Fillister head screws M4x20mm
4 Plastic washers 4mm
4 O-rings 3.5x1.5mm
4 Distance sleeves 3mm
1 Edge protection strip with clamping
sleeves
Fitting the windscreen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Disassemble the original windscreen.
3. Insert the 4x20mm lens head screws [11496] with the plastic washers [10681] into the
holes on the MRA windscreen. Then, place the 3mm distance sleeves [11498] against
them from behind. Secure these with the small O-rings [11495], as shown in image 1.
4. Now, mount the MRA windscreen onto the motorcycle. First, place all the screws and
align the windscreen. Then tighten all the screws.
5. Hoist the edge protection profile up onto the rear exposed area of the windscreen,
starting from the fillet and going to the opposite side. Cut off the rest if required.
6. Push the clamping sleeves over the ends of the protective edge strip profile and lightly
press these together using a pair of pliers to secure the protective edge strip profile.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Aprilia Tuono 660 2021-
Article No..
--- Allen key 2.5mm
11496
10681
11495
11498
---
3
Required tools