Troubleshooting - Coplax stylies LUNA Instrucciones De Uso

To avoid lime scales
• Use clean and softened water, cold boiled water, or distilled water.
• Clean the Reservoir, especially the surface of the Oscillator weekly.
• Dry the unit (Reservoir, Inner Cap, Cover Cap) completely with clean soft cloth after your
use and before storage.
Descaling and Cleaning
• Switch off the unit by pressing the Control Button and disconnect the Adaptor from main
supply.
• Remove the Cover Cap and the Inner Cap, put few drops of white vinegar into the Reser-
voir, let the vinegar cover the surface of Oscillator, and leave it for 5 minutes (the longer
the better cleaning results).
• Clean off the scale with soft cloth.
• Rinse all the parts (Cover Cap, Inner Cap, Reservoir ) with fresh clean water. Note: be
careful not to let water running into the Base Unit.
• Dry all parts with soft cloth and put Inner Cap and Cover Cap back onto the Base Unit.
IMPORTANT:
Do not use cleaning agents or other scouring agents to clean the unit.
Do not use any metal or hard objects to clean the Oscillator.
TROUBLE-SHOOTING
Problem
Unit switched on, but no
mist coming out
Unit is on, the illumination
light is on, but no mist
and no fragrance sensed
Unit gives only small
amount of mist and
almost no fragrance
sensed from the unit
Unit gives bad smell: not
as the fragrance added.
REPAIRS / DISPOSAL
Repairs to all electric devices (including replacement of the power cable) may only be performed
by instructed experts. Carrying out inappropriate repairs voids the warranty and no liability shall
be accepted.
If the power cable has become damaged, it must be replaced by the manufacturer, his official
service partner or a qualified person, in order for further damage to be avoided.
Never operate the device if the cable or the plug is damaged, after the device has malfunc-
17
Possible Cause
Adaptor not properly
connected with the unit
and the main supply
Reservoir is empty
Reservoir and Oscillator
is covered with scale or
water level is too high
Reservoir is dirty or
not properly cleaned
before change to the new
fragrance
Solution
Check if the Adaptors
Plug is properly inserted
into main supply socket
and with the Adaptor
socket on the Base Unit
Check, and refill the
Reservoir with water and
fragrance
Clean the unit and
remove the scale, or take
out some water from
Reservoir
Clean the unit, and refill
with fresh water and the
fragrance