How To Use The Head Up/Down Mechanism; How To Use Media Edge Guards - SII IP-7700-02/03 Guía De Consulta Rápida

How to use the head up/down mechanism

The printer automatically adjusts the head height to the best
height when the printer is turned on or when media is set. To
adjust the head height according to the media to be used,
select MEDIA REG MENU on the operation panel and adjust
the head height.
Note
-
Adjust the head height so that the head does not contact
with the media. Friction of the head may cause poor firing of
the head and degrade the print quality. On the other hand,
excessive head height from the media will also degrade the
print quality. Use the printer with the head height that is
automatically adjusted by the printer.
1
Set the printer to the offline state.
Press the O N L I N E
á I N K M E D I A R E G â
ß M E D I A

How to use media edge guards

To protect the print head from warp and feathering at both
ends of media, use media edge guards in the media feed
path and slide it to meet the media width.
(Wiping station side)

key.
M . A D V à
(Capping station side)
Media edge guards
2
Press the key to display the MEDIA REG
MENU.
# S E L E C T M E D I A
> 0 1 : T Y P E 0 1
3
Press the key and then
display [PH HEIGHT VAL].
# P H H E I G H T V A L
> 0 1 : + 0 . 0 m m
4
Press the key, and enter the head height
adjustment value with the
# P H H E I G H T V A L
> 0 1 : + 0 . 1 m m
The adjustment value range is: -0.3 to +1.0 mm.
5
Press the key to determine the adjustment
value.
[Media edge guard specifications]
- Capable of media thickness of up to 1 mm.
- Decreases the print area.
- Reduces the effect of the suction fan.
Note
-
Make the media edge guard usage setting in the MEDIA REG
MENU from the operation panel. The right and left margins of
the media are controlled by this setting.
- When media edge guards are used, the right and left print
area margins increase to 10 mm. (When no media edge guard
is used, the margins are 5 mm.)
- When the media edge guard is stained, wipe it out.
-
Remove feathering that cannot be removed by the media
edge guard beforehand as it may cause nozzle-out.
or key to
or key.