Settings - Project MDI80 Manual Del Usuario

GB
All manuals and user guides at all-guides.com
e) Check the operation of the machine limit switch. It must stop motor
and pump operation when a rack reaches the end of the table.
Operation must start again when the rack is removed.
f) Check the rotation direction of the pumps and motors, if they rotate
in the opposite direction invert the two phases of the power supply
cable.
NOTE:
Check the rotation of the sledge. The reduction gearbox must
rotate clockwise (as in the figure), otherwise, invert the phase in
the power cable.
WARNING: If the sledge is rotating in the direction opposite to
that shown, the safety feature is disabled!
The non-observance of such inspections will result in the
invalidation of the warranty.
1- WASHING DIRECTION SELECTION
ON ⇒ Machine with drum opening on left
OFF ⇒ Machine with drum opening on right
2- AUTOTIMER SELECTIONS
ON ⇒ Machine starts when drum is inserted.
OFF ⇒ Machine starts manually.
3- HEATING SELECTION
ON ⇒ Machine operating at the same time as the tub heating
elements and boiler.
OFF ⇒ Machine with operation alternating with the tub heating
elements and boiler.
4- BOILER HEATING SELECTION
ON ⇒ Machine with rapid boiler heating element heating.
OFF ⇒ Machine with slow boiler heating element heating.
CAUTION:
Never position during first installation if you are uncertain (see 2.7)
Page. 11
2.11

SETTINGS