Preparation
Preparation
Preparation
Preparation
Preparation
1. 1. 1. 1. 1.Unpacking
Remove all packing materials. The door protective film and the
table protective film should also be removed.
2. 2. 2. 2. 2.Check attachments and materials
Checking should be conducted with reference to the Packing
List. Contact the local distributor if discrepancies are found.
3. 3. 3. 3. 3.Ensure proper location of the refrigerator.
(Refer to the section of "Location")
4. 4. 4. 4. 4.Clean the refrigerator before using.
(Refer to the section of "Cleaning")
5. 5. 5. 5. 5.Standby status
Connect the power source a minimum of 30 minutes after the
refrigerator has been sited and cleaned.
Caution:
After unpacking, write down the model and delivery number of the refrigerator on
the Warranty for future inquiries.
5
All manuals and user guides at all-guides.com
Preparation
Preparation
Preparation
Preparation
Preparation
Left/Right Door Opening
Left/Right Door Opening
Left/Right Door Opening
Left/Right Door Opening
Left/Right Door Opening
The door of the refrigerator can be opened both from the left or
right as required. The following are the steps required to
position the door to open to the right.
1.Firmly hold the refrigerator door and remove the
screws from the right lower hinge. Remove the door
and place aside. Remove the lower pivot pin and
install it in the left lower hinge hole.
2.Remove the middle hinge and the washer on the
middle connection and then the freezer door. Put the
door aside.
3.Remove the pivot pin from the upper right hinge and
install it on the left, then remove the screws on the
left of the middle connection.
4.Place the freezer door on the left side of the housing.
Remove the middle pivot pin from and then insert it
from the other side of the middle hinge. Fix the middle
hinge on the left side of the housing.
5.Mount the refrigerator door with the top left hole on
the down pivot pin of the middle hinge.
6.After installation, open and close the door several
times and fix tighten the hinge screws when the door
operates normally.
Lower hinge
Lower pivot pin
Lower pivot pin hole
Pivot pin hole
Middle pivot pin
Washer
Middle hinge
Hole stoppers
Middle pivot pin
Washer
Middle hinge
Lower hinge
Lower pivot pin
6