Inverting The Doors And Fitting The Handles - Haier HRF-370IT Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 67
English
5. The inside light is not working
If the light is not working, check that:
- the mains electrical supply is present;
- the door switch is not stuck;
-
If necessary, unplug the appliance from the
mains, remove the lampcover, releasing the clip (A);
- check that the bulb is not simply loose, tightening it if
necessary;
- if the bulb is faulty, replace it with another with the same
wattage and voltage; the maximum wattage is indicated
on the lamp cover.
Take care when handling the bulb, in case it is
still hot.
- Put the the lamp cover back on and plug the appliance
back into the mains.
- Check that the light works when the door is opened and
that it switches off when the door is closed.
6. Water collects at the bottom of the refrigerator
compartment
Check that:
- the water drain outlet, at the rear of the compartment, is
not blocked. Clean it if necessary.

INVERTING THE DOORS AND FITTING THE HANDLES

Before any intervention, unplug the appliance
from the mains.
To remove the appliance doors, proceed as follows:
1. unscrew the handles of the refrigerator and freezer com-
partment doors;
2. remove the bottom plinth and unscrew the lower right
hinge (fig. A);
3. release the freezer door from the pin, pushing it
downwards;
4. gripping the refrigerator door firmly, unscrew the middle
hinge and release the refrigerator door from the pin, pus-
hing it downwards;
All manuals and user guides at all-guides.com
- 9 -
NOTE
Be aware of the general conditions of the warranty and its
expiry date, indicated on the attached certificate or on
that provided by the dealer at the moment of purchase.
The appliance warranty does not cover after-sales servi-
ce call-outs to repair malfunctions caused by failure to
observe the recommendations and advice provided in this
user manual.
If the power supply cable needs to be replaced,
unplug the appliance from the mains and fit a new
cable, which must be ordered from the After-sales Service.
Make sure it is properly connected and secured. If, after per-
forming the above checks, the appliance is still not working
normally, contact the After-sales Service, whose contact
details are given on the warranty and in the telephone direc-
tory; state the nature of the fault, the appliance model and
service number.
To avoid risks and to ensure the warranty is not rendered
null, have all repairs and maintenance operations carried
out exclusively by qualified personnel provided by the
After-sales Service.
The manufacturer is constantly working to update and impro-
ve products. Confident you will excuse any inconvenience,
we reserve the right to make modifications to the design,
accessories and technical specifications of this appliance.

Publicidad

Tabla de contenido
loading

Tabla de contenido