Installing Handle; Removing Handle - RIDGID 1600RV Manual Del Usuario

SP6940-1 1600RV0_1_SP6940-1 1/22/15 2:28 PM Page 8
Drum/Base Assembly (Continued)

Installing Handle

Press and hold release buttons while
installing handle into handle receptacles
in drum (See illustration).
NOTE: An audible snap of release
buttons indicates successful engagement
of handle.

Removing Handle

Press and hold release buttons as
shown. While firmly pushing in release
buttons, pull handle upwards to remove
(see illustration).
Installing Accessory Holder
Attach the flexible end of the accessory
holder at the top of the Vac drum.
The non-elastic end should be located
at the bottom of the Vac drum.
Install accessory holder as shown with
the 4 screws included.
Tighten screws so that there is a small
clearance between the screw head and
the grommet on the accessory holder.
Note: If no screw head to grommet
clearance, the accessory holder will
twist with the screws.
All manuals and user guides at all-guides.com
8
Metal
Handle
Release
Buttons (2)
Handle
Receptacles (2)
Flexible End
Accessory
Holder
Accessory
Holder
Screw (4)
Non-Elastic
End