Ferm BJM1009 Traducción Del Manual Original página 8

• A ssemble the bottom plate (20) again and fix
the 4 screws.
Make sure that the top of the base plate
is securely closed before operating the
machine.
Mounting the dust bag
Fig. A
For dust extraction the dust bag (13) can be used.
Connect the dust extraction adapter (12) to the
machine, then connect the dust bag (13) to the
adapter. Empty the dust bag regularly so that the
vacuuming performance remains intact.
A vacuum cleaner can be directly connected to
the dust extraction adapter when use of a vacuum
cleaner is preferred.
5. OPERATION
Never use the spindle lock while the
machine is running.
Switching on and off
Fig. A
• T o switch the machine on slide the on/off
switch (1) forwards.
• T o switch the machine off, depress the on/off
switch (1), the switch will automatically move
to the 'off' position.
Never use the spindle lock to stop the
motor.
Marking the workpiece
Fig. E
Before starting with the Biscuit Jointer the
workpieces must be marked as following.
• P lace the two surfaces which must be
connected, with their connecting side to each
other
• C lamp the work pieces and mark the center of
the groove by drawing a perpendicular line
• S everal joints will be required for larger
workpieces. The distance between two drawn
lines should be at least 10cm.
8
All manuals and user guides at all-guides.com
Sawing grooves
Fig. F
• S et and check the cutting depth on the
• S et the angle on the machine
• S et the height on the machine, take care for
• M ake sure the workpiece is securely clamped
• P osition the machine on the workpiece, the
• H old the machine with both hands and switch
• P ush the motor base carefully forward as far
• M ove the motor base backward and switch the
Joining the workpieces
When the grooves in both workpieces have been
made the workpieces can be joined together.
• P ut glue in both grooves.
• P lace the biscuit dowel in the groove of one
• P lace the other workpiece on the biscuit
• F asten the workpieces and wait till the glue is
User tip for connecting two workpieces
• S aw a groove as big as one biscuit into the first
• P lace the biscuit with good glue (according the
• S aw a longer groove into the other workpiece
• N ow both workpieces can be positioned easily
• F asten the workpieces and wait till the glue is
machine
setting the height, the groove for the biscuit
dowel must be in the middle of the workpiece.
marked centerline (15) must be in line with the
line drawn on the workpiece
the machine on.
as possible.
machine off.
For workpieces thinner than 16 mm it is
not possible to cut the groove in the
middle of the workpiece without adding
an adjustment plate below your
workpiece (fig. G).
workpiece.
dowel.
dry.
workpiece
material) into the groove
towards each other (clearance to correct)
dry
Move the machine in the same direction
as the direction of rotation. See arrow on
top of the machine.