Ferm BJM1009 Traducción Del Manual Original página 9

Fine adjusting the cutting depth
Fig. B
When the cutting depth is not correct, it can be
adjusted as following.
• M ove the motor base (3) as far as possible
backwards.
• L oosen the nut on the fine adjustment screw
while keeping the screw in position by using a
screw driver
• I ncrease the cutting depth by turning the
screw (10) counterclockwise.
• D ecrease the cutting depth by turning the
screw (10) clockwise
• R epeat the procedure till the cutting depth is
correct.
• F asten the nut on the fine adjustment screw
(10) again while keeping the screw in position
by using a screw driver
6. MAINTENANCE
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
The machines have been designed to operate
over along period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Cleaning
Keep the ventilation slots of the machine clean to
prevent overheating of the engine.
Regularly clean the machine housing with a
soft cloth, preferably after each use. Keep the
ventilation slots free from dust and dirt. If the dirt
does not come off use a soft cloth moistened with
soapy water. Never use solvents such as petrol,
alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Lubrication
The machine requiers no additional lubrication.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
All manuals and user guides at all-guides.com
an exploded view showing the parts that can be
ordered.
In case of excessive sparking of the machine,
have the carbon brushes checked only by a
qualified electrician.
ENVIRONMENT
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
WARRANTY
The guarantee conditions can be found on the
separately enclosed guarantee card.
Faulty and/or discarded electrical or
electronic apparatus have to be
collected at the appropriate recycling
locations.
9