Descaling The Appliance - Silvercrest SEM 1100 B3 Instrucciones De Uso

Descaling the appliance

Descale the appliance regularly. The appliance should be descaled after about
1- 2 months (at approx. 4 espresso preparations per day). Depending on the
hardness of the water in your area, this figure may differ.
For descaling, use a commercially available descaler for espresso machines.
Proceed as described in the instructions for usage of the descaler.
If you do not have any descaling products, you can use citric acid and proceed
as follows:
1) Fill the water tank
2) Dissolve 2 tablespoons (about 30 grams) of citric acid (available in drugstores
or chemists) into the water.
3) Replace the water tank
4) Switch on the appliance using the On/Off switch
is closed.
5) Insert the sieve holder
appliance and place a cup under the sieve holder
6) As soon as the green heat-up indicator lamp
button
7) Allow around 2 cups (approx. 250 ml) of water to run through and then stop
the process by pressing the "Espresso" button
8) Hold a container under the milk frother
9) Press the "Steam" button
until the green heat-up indicator lamp
control
about 2 minutes.
10) After 2 minutes, close the steam control
again so that no more steam is generated.
11) Let the scaling agent take effect for about 15 minutes.
12) Repeat steps 6 - 11 three times.
13) Then press the "Espresso" button
water run through until the water tank
14) Rinse the water tank
to the Max marking.
15) Press the "Espresso" button
until the green heat-up indicator lamp
16) Allow the water to run through.
17) Repeat steps 14 - 16 three times.
18) Refill the water tank
SEM 1100 B3
to the marking MAX.
into the appliance.
without the espresso sieves
so that it clicks in.
down so that it clicks into place and wait
to the position " + ". Allow the appliance to create steam for
with clean water and then fill it with clean water up
with water.
. The steam control
.
lights up, press the "Espresso"
again.
.
lights up. Slowly turn the steam
, then press the "Steam" button
down so that it clicks in, let the
is empty.
down so that it clicks into place and wait
lights up.
GB │ MT
back into the
│ 91 ■