Craftsman 919.184193 Manual Del Propietário página 24

PROBLEM CAUSE
Excessive belt Loose belt.
wear
Tight belt.
Loose pulley.
Pulley misalignment.
Squealing Compressor pump has
sound no oil.
Loose belt.
Oil and/or Water condensation
moisture in
Oil blow-by in pump
tank and/or air
lines
All manuals and user guides at all-guides.com
CORRECTION
Loosen wingnut and then tighten
wingnut until it contacts the washer,
plus one turn.
Loosen wingnut and then tighten
wingnut until it contacts the washer,
plus one turn.
Have checked by a Trained Service
Technician.
See Motor Pulley/Flywheel
Alignment paragraph in the
Maintenance section.
See Oil-Checking paragraph in the
Maintenance section.
Loosen wingnut and then tighten
wingnut until it contacts the washer,
plus one turn.
It is normal for oil lube air
compressor pumps to release some
oil into the tank and air lines. Air
compressors will also generate
water condensation that will form in
the tank and air lines. Install water
and oil filter traps when needed.
The Typical Compressed Air
Distribution System paragraph
under Installation provides a
guideline. Contact a Trained Service
Technician f or more information.
IMPORTANT: If the tank or air lines
have excessive water and/or oil,
contact a Trained Service Technician.
24-ENG