Power Cord - Burda RELAX DARK IRC IP55 Uso Y Mantenimiento

POWER CORD:

• The use of an extension cord with this appliance
is not recommended.
• The power cord must not come into contact with
heated parts of the device!
• Children aged from 3 years and less than 8
years shall not plug in, regulate and clean the
appliance or perform user maintenance.
• Never remove the plug from the socket by pull-
ing on the cord! Never move the device by pulling
on the cord or
carry the device by the cord!
• Do not wind the cord around the device! Do
not operate the device with the cord wound up!
• Do not clamp the cord, or pull it over sharp
edges!
• Do not run cord under carpeting, throw rugs or
runners etc. Arrange cord away from areas where
it is likely to be tripped over.
•Never use the appliance if the appliance or
cord is damaged. Risk of injury!
• The energy supply to the heater must always be
properly earthed.
• The appliance must not be located neither
directly below, nor in front of a socket-outlet.
• The heater must be installed so as to prevent
that the switches can be touched from those who
are in the shower.
• If the appliance is not used for a long period,
disconnect it from the power supply.
INSTALLATION:
• The installation should always be carried out
by a qualified electrician or a competent person
in accordance with the current electrical standards
for your country:
(ex. HD 384 CENELEC for Mainland Europe, IEC
60446 and BS
7671 for the United Kingdom, IEC 60445(2010) &
ET101:2008 for Ireland and IEC 60364-7 1988
Internationally, AS/NZS 3000 for Australia) and
according to the UE 2015/1 188 standards. Risk
of fire!
• Only commission the device after it has been
fully installed.
• This heater comes with a pair of stainless steel
adjustable angle mounting brackets. The adjust-
able angle enables the heater to be installed on
horizontal and inclined surfaces.
NOTE:
- After switching on the appliance for the first time
and following extended periods on non-use, the
appliance may expel a slight odor for a short time.
It will not affect the use of the heater.
- To exclude unpleasant burnt odor, it is recom-
mended to keep the heater clean preventing
accumulation of dust on it
INSTALLATION:
In case of direct connection to the supply line, a
bipolar switch or a bipolar circuit breaker with
contact opening distance of at least 3mm must be
fitted upstream from the supply line. Contact an
authorized service technician if you are unsure if
you have a switch or a circuit breaker installed on
the premises.
- Plug in the device in the socket of main power, the
heater starts heating.
- Unplug the device from the socket or press the
switch or the circuit break to power off the device.
CLEANING:
• First, disconnect the equipment from the power
supply system!
• After the appliance has cooled down, wipe off
dust with a damp soft rag.
• During operation, it is necessary to periodically
(once a year) check the electric cable contacts
and terminal connectors for good tightening.
• Make sure all parts are dry before using again.
• Do not use any abrasive or caustic cleaning
agents!
• Never immerse the appliance in water! Danger
to life!
AFTER-SALES SERVICE:
• All repairs must be referred to authorised
personnel! Therefore, you should contact your
specialized dealer or the customer service.
GB