Reggiani KYLIOS Instrucciones Para El Instalación página 17

KYLIOS | ENG |
• For LEDs:
The projectors are supplied with the LED
already installed.
Remove the blue protective film before
switching on the LED (fig.5 A).
Do not touch the LED; in particular, avoid
the use of pointed tools which could
otherwise damage internal connections.
The reflector twist-lock fixing system (fig.5
B) (present on most products equipped
with the LED) allows the adjustment of the
beam from narrow to wide or Wall Washer
Mira (refer to the catalogue or access the
product datasheet on the website:
www.reggiani.net/reference
corresponding accessory).
Arrange the retainer tabs in the optical
compartment. Press and turn the reflector
clockwise until it snaps into place (fig.5 C).
The Wall Washer Mira reflectors enable
additional adjustment of the elliptical
beam by rotating the shield.
There is no provision for replacing the
light source on LED projectors. If any
malfunction occurs, contact Reggiani Spa
Illuminazione to replace the luminare.
www.reggiani.net
All manuals and user guides at all-guides.com
for the
5
A
5
B
5
C
014