KPS -LX30LED Manual De Funcionamiento página 35

• In this mode, when measurement value exceeds present range, "OL" will
appear on LCD interface to indicate over-range, and the user should switch
KPS-LX30LED • Digital light meter
over the measurement range at this time.
5.2 Relative/peak value measurement mode
tive value measurement mode.
• Press and hold REL/PEAK key for a short time (composite key for relative/
peak value measurement), "REL" will appear on the top left position of the
position of the LCD interface will disappear, and the device will exit the re-
LCD interface (as shown in figure 5-1-2A), and the device will enter the rela-
lative value measurement mode and return to original measurement mode.
• Press and hold REL/PEAK key for a short time again, "REL" on the top left
peak value measurement mode, "PEAK"LCD will appear on the top right
position of the LCD interface, and at the same time, "MENU" will appear on
• Press and hold "REL/PEAK" key for one second, the device will enter the
• Press and hold the key once again for one second, "PEAK" on top right po-
sition of LCD interface will disappear, and "AUTO" will appear on the middle
of LCD interface, and the device will exit the peak value measurement mode
the top left position of the LCD interface (as shown in figure 5-1-2B).
and return to auto measurement mode (as shown in 5-1-2C).
• Only in auto measurement mode, peak value measurement mode, max/min
Figure 5-1-2A
value inquiry mode and data hold mode, it will be effective to press and hold
REL/PEAK key for a short time.
• In non-zero calibration mode, press and hold "REL/PEAK" for one second,
Tips
Figure 5-1-2B
35
Figure 5-1-2C