Troubleshooting - Philips AZ 1018 Manual Del Usuario

All manuals and user guides at all-guides.com
If a fault occurs, first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the guarantee.
Problem
No sound
No power
Display does not function
properly/ No reaction to
operation of any of the
controls
no d1SC, Cd Err or
nF d1SC indication
Laser lens steamed up
CD playback does not work
The CD skips tracks
Poor cassette sound quality
Recording does not work
Solution
– Adjust the VOLUME
– Mains lead not securely connected.
Connect AC mains lead properly
– Batteries exhausted /incorrectly inserted.
Insert (fresh) batteries correctly
– Electrostatic discharge
Switch off and unplug the set.
Reconnect after a few seconds.
– No CD inserted, insert a CD
– CD badly scratched/ dirty.
Replace/ clean CD (see maintenance)
– CD-R(W) is blank or the disc is not finalized.
Use a finalized CD-R(W)
– Laser lens steamed up.Wait until lens has acclimatized
– Wait until lens has cleared
– Wait until lens has acclimatized
– CD badly scratched/ dirty.
Replace/ clean CD (see maintenance)
– CD damaged or dirty. Replace or clean CD.
– Programme is active. Quit programme mode
– Dust and dirt on the heads, etc.
Clean deck parts, see maintenance.
– Use of incompatible cassette types (METAL or
CHROME). Only use NORMAL (IEC I) for recording
– Cassette tab(s) may be broken.
Apply a piece of adhesive tape over the missing tab space.

Troubleshooting

15