Operating Tips - SNOWJOE iON100V-24SB-CT Manual Del Usuario

4. During backing up, pay attention not to squeeze the auger
trigger. The snow blower will stop if auger is triggered
during back up. If this happens, release both triggers and
press the reverse button again to restart backing up.
NOTE: When the reverse button is pressed, the reverse mode
is activated for 15 seconds. If the drive trigger is not squeezed
within 15 seconds, the snow blower will exit the reverse mode.

Operating Tips

m
WARNING!
Foreign objects, such as rocks, broken
glass, nails, wire, or string, can be picked up and thrown by
the snow blower, causing serious personal injury. Remove all
foreign objects from the area to be plowed before operating
the snow blower.
Snow is best removed as soon as possible after snow fall.
1. Keep the area of operation free of foreign objects that can
become thrown by the rotor blades. Perform a thorough
inspection of the area since some objects may be hidden
from view by surrounding snow. If the snow blower hits
an obstruction or picks up a foreign object during use,
stop the snow blower, remove the batteries, remove the
obstruction, and inspect the unit for damage. Repair or
replace any damaged part before restarting and operating
the unit.
2. Keep children, pets, and bystanders away from the area of
operation. Be aware that the normal noise of the machine
when turned on may make it difficult for you to hear
approaching people.
3. For larger areas, a definite pattern of operation is required
to thoroughly clean an area of snow. These patterns
will avoid throwing snow in unwanted places, a well as
eliminate the need for a second removal of snow (Fig. 27).
Pattern A: Throw the snow to the right or left side where
it is possible. For areas such as a long driveway, it is
advantageous to start in the middle. Plow from one end to
the other, throwing snow to both sides.
Pattern B: If the snow can only be thrown to one side of
the area to be cleared, start on the opposite side.
Fig. 27
pattern A
pattern B
4. Note the wind direction. If possible, move in the same
direction as the wind so that the snow is not thrown
against the wind (and thus back into your face and on the
just cleared path).
5. Do not push the snow blower with excessive force. Do not
exceed the unit's intake or throw rate.
6. Some parts of the snow blower may freeze under extreme
temperature conditions. Do not attempt to operate the
snow blower with frozen parts. If the parts freeze while
the snow blower is in use, stop the snow blower, remove
the batteries, and inspect for frozen parts. Free all parts
before restarting or operating the snow blower. Never
force controls that have frozen.
Maintenance
To order genuine replacement parts or accessories for
the Snow Joe iON100V-24SB-CT cordless snow blower,
®
please visit snowjoe.com or contact the Snow Joe
Sun Joe customer service center at 1-866-SNOWJOE
®
(1-866-766-9563).
m
WARNING!
Make sure to turn off the snow blower and
remove the batteries before performing any maintenance task
on your snow blower.
General Maintenance Tips
1. Do not attempt to repair the machine unless you have the
proper tools and instructions for disassembly and repair of
the machine.
2. Check bolts and screws at frequent intervals for proper
tightness to ensure that the equipment is in safe
working condition.
17
+
®