Chapter 2. Installation Guide; Hardware Installation; Software Installation; For Windows® Xp - aqprox appPCI300 Guía De Usuario

300Mbps Wireless N PCI Adapter – APPPCI300

Chapter 2. Installation Guide

2.1 Hardware Installation

To install the adapter, follow these steps listed below:
1. Turn off your desktop PC and disconnect the power.
2. Remove your PC case and locate an available PCI slot on the mianboard. Remove the metal
slot cover on the back of the PC. Check with your computer manufacturer for instructions if
needed.
3. Slide the PCI Adapter into the PCI slot. Make sure that all of its pins are touching the slot's
contacts. Once the adapter is firmly in place, secure its fastening tab to your PC's chassis
with a mounting screw. Then, close your PC case.
4. Reconnect your PC's power and turn on your desktop PC.

2.2 Software Installation

2.2.1 For Windows® XP
The Setup steps for Windows® 2000 and XP are similar with each other. This user guide takes
Windows® XP for example.
1. Insert the Resource CD into your CD-ROM drive. To continue, find the CD/DVD drive
where the installation CD was placed. Open APPPCI300 folder, and double-click
Setup.exe. Then you will see Figure 2-1.
User's Guide
Figure 2-1
English
44