M-nr 11313370
After service work
– Carry out appropriate safety tests.
– Check the machine for correct operation.
Risk of cuts
WARNING
Components are sharp.
Risk of cuts during service work.
A
Wear protective gloves.
Risk of injury due to excessive physical strain
WARNING
Risk of injury due to excessive physical strain.
Spinal injuries.
A
The relation of the weight of the machine to the physical strength of the technician must be taken into account.
For machine weight details, see the operating instructions.
Stand preparation
A
Level the stand on the floor.
A
Mark the hole positions.
A
Drill 16mm dia. holes in the marked positions approx. 120mm deep.
A
Insert the plugs in the holes.
A
If a dryer is to be installed on the stand, secure each clamping plate to the rear of the stand with two 6x12 screws;
see Fig. 1.
A
Level the stand using the provided washers (2); see Fig. 2.
A
Fasten the stand to the floor with the provided wood screws (3) and B13 washers (4); see Fig. 2.
Installing a washing machine on the stand
A
Unscrew and remove the machine feet.
A
Install two M10 nuts on each M10 set screw and tighten them so that 15mm ± 1mm of thread protrudes; see Fig. 3.
A
Install the M10 set screws with the 15mm-long side in place of the machine feet and screw them in as far as they will
go; see Fig. 3.
A
Install a B10.5 washer on each set screw.
A
Lift the washing machine onto the stand, pushing the set screws into the stand.
A
From inside the stand, install one B10.5 washer and one M10 nut on each set screw and tighten; see Fig. 3.
Installing a dryer on the stand
A
Unscrew the dryer feet by at least 5mm.
A
Place the dryer on the stand and slide its rear feet into the clamping plates.
A
Level the dryer on the stand.
A
Screw one M6x20 screw (1) into each of the clamping plates and tighten; see Fig. 4.
en-US
el
Dessa underlag får inte mångfaldigas eller göras tillgängliga för tredje part utan medgivande från Miele AB. Med ensamrätt.
Ombyggnads- och monteringsanvisning
11 av 34
2019-07-01