Installation; Mounting - Resol PSW Basic Manual

2

Installation

2.1 Mounting

80
WARNING! Electric shock!
Upon opening the housing, live parts are
exposed!
Î Always disconnect the device
from power supply before
opening the housing!
Note
Strong electromagnetic fields can impair the functi-
on of the device.
Î The device is suited for stationary mounting
only. Pay attention to strain relief when routing
the cables.
The unit must only be located in dry interior rooms. It is
not suitable for installation in hazardous locations and
should be protected against electromagnetic fields.
If the device is not equipped with a mains connection cable
16
and a plug, the device must additionally be supplied from
a double pole switch with contact gap of at least 3 mm.
Please pay attention to separate routing of sensor cables
and mains cables.
In order to mount the device to the wall, carry out the
80 following steps:
1.
2.
3.
4.
5.
6.
7.
Determine the mounting site and mark the holes th-
rough the fastening points.
Drill holes and insert the wall plugs.
Fasten the housing.
Unscrew both screws.
Remove the upper part of the housing.
Carry out the electrical connection.
Attach the upper part to the housing and tigthen both
screws.