Presetting Radio Stations - Sony STR-DE335 Manual De Instrucciones

Presetting Radio Stations

You'll most likely want to preset the receiver with the
radio stations you listen to often so that you don't have
to tune in the station every time. The receiver can store
a total of 30 FM or AM stations. You can store the
stations on preset numbers combining 3 characters (A,
B, C) and numbers (0 - 9). For example, you can store a
station as preset number A1, B6 or C9, etc.
PRESET
Numeric
TUNING +/– NAME
buttons
SHIFT MEMORY TUNER
1
Press TUNER.
The last received station is tuned in.
2
Tune in the station you want.
If you are not familiar with how to tune in a
station, see "Receiving Broadcasts" on the
previous page.
3
Press MEMORY.
"MEMORY" appears for a few seconds.
Do steps 4 and 5 before "MEMORY" goes out.
4
Press SHIFT to select a character (A, B or C).
Each time you press SHIFT, the letter "A," "B" or
"C" appears in the display.
If "MEMORY" disappears, start again from step 3.
5
While MEMORY is displayed, press the number
you want to use (0 to 9).
6
Repeat Steps 2 to 5 to preset other stations.
To change a preset station
Preset a new station on the number you want to change.
Note
If the mains lead is disconnected for about one week, the
preset stations will be cleared from the receiver's memory,
and you will have to preset the stations again.
+/– ENTER
Receiver Operations
Tuning preset stations (preset tuning)
You can tune directly to a preset station by entering its
preset number. If you don't know which stations are
preset on which numbers, you can tune by scanning
the preset stations.
1
Press TUNER.
The last received station is tuned in.
2
Press SHIFT to select a character (A, B or C), then
press the number.
For example, select A and then press 7 to tune in
the station preset as A7.
You can tune by scanning the preset stations
First press TUNER and then press PRESET TUNING
+ or – to select the station you want. Each time you
press the buttons, the preset numbers change as follows:
n A1 ˜ A2 ˜... ˜ A0 ˜ B1 ˜ B2 ˜ ... ˜ B0 N
n C0 ˜ ... ˜ C2 ˜ C1 N
Naming preset stations
You can store names, up to 8 characters long, for your
preset stations. Once you name a preset station, the
name appears in the display instead of the frequency
when you tune to that preset.
The characters you can use include letters, numbers
and symbols.
1
Tune to the preset station you want to name.
2
Press NAME.
The cursor blinks in the display.
3
Use + or – to select the character you desire.
4
Press NAME to move the cursor into position for
the next character.
5
Repeat steps 3 and 4 to enter up to 8 characters.
6
Press ENTER to store the names.
If you make a mistake
Press NAME repeatedly so that the character you want to
change blinks in the display, then use + or – to select the
desired character.
Notes
• You can also enter a name of up to 8 characters for
program sources. Select the program source you want and
repeat steps 2 to 6.
• To clear program source name, press NAME and then
press the same program source button. Press ENTER to
delete the name (except TUNER).
13 US