Unpacking; Packing List; Assembly - Ryobi RY40PW15 Manual Del Operador

UNPACKING

This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the Packing
List are included.
WARNING:
Do not use this product if any parts in the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.

PACKING LIST

40 Volt Pressure Washer
Wheel Assembly
Handle
Handle Cover
Screws (4)
25 ft. High Pressure Hose
Trigger Handle
Spray Wand
Nozzles (15º, Turbo, Soap)
Self Priming Adapter
Male Quick Connect
10 ft. Quick Connect Siphon Hose w/Filter
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.

ASSEMBLY

WARNING:
Do not insert the battery pack until assembly is complete.
Failure to comply could result in accidental starting and
possible serious personal injury.
ATTACHING THE HANDLE TO THE WHEEL
ASSEMBLY
See Figure 2.
 Insert the base of the handle into the wheel assembly as
shown.
 Secure the handle with two Phillips screws. Hand tighten
only. Do not overtighten.
INSTALLING THE HANDLE AND WHEEL
ASSEMBLY TO THE PRESSURE WASHER
See Figures 3 - 5.
 Slightly tilt the pressure washer base forward.
 Align the curved tab on the wheel assembly with the slot
at the base of the pressure washer.
 Insert the tab at a slight downward angle and move the
handle and wheel assembly upward while pushing it into
the unit.
 With the handle flush to the back of the unit, install the
handle cover.
 Secure the handle cover using the two remaining Phillips
screws. Hand tighten only. Do not overtighten.
CONNECTING THE SPRAY WAND TO THE
TRIGGER HANDLE
See Figure 6.
 Push the end of the spray wand into the trigger handle
and rotate clockwise to secure.
 Pull on the spray wand to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE
TO THE TRIGGER HANDLE
See Figure 7.
 Screw the collar on the high pressure hose into the trigger
handle inlet coupler by turning the hose collar clockwise.
Tighten securely.
NOTE: Be careful to avoid cross-threading, which can
cause the trigger handle to leak during use.
 Pull on the hose to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE
TO THE PUMP
See Figure 8.
NOTE: For additional information, see Connecting the
Siphon Hose to the Pressure Washer later in Assembly if
you are going to connect to a non-pressurized water source.
7 — English