4.AUX FUNCTION
·.In radio/USB/SD/MMC station, press (MOD) button to choose AUX
line-in function, it will change to AUX line-in station, LCD display
"AUX-ON"
· In AUX line-in station, press (MOD) button to return to radio
5.CLOCK FUNCTION
5-1 Clock Display
Press (CLK) button shortly to display clock and it will exit after several
seconds, or press any button to exit.
5-2 Clock Adjustment
Press long (CLK) button to clock adjustment, when HOUR figure flicker,
press /<< or >>/ button to up/down hour figure; then press (CLK) button
shortly, minute figure flicker, press /<< or >>/ button to up/down minute
figure. After adjust minute, press <CLK> button shortly to finish.
6. Electrical Connection
Many vehicles are pre-fitted with ISO connectors behind the dash,
including all the electrical cabling for a car radio. In such cases, the
connections fitted to the vehicle can be directly plugged into the car radio
connectors. Should your car not be pre-fitted with these connectors, we
strongly advise you to obtain the ISO wiring loom fitted with the male
connector for connection to your car radio either from a specialist shop or
from the concessionaire for your vehicle. Once obtained, you will only
need to connect your loudspeakers and the power supply to the ISO
connector, following connection instructions provided with same.
1. Make sure your car battery is a 12 volt (6filler caps) negative ground
system (if not, a converter will be necessary).
2. Before starting wiring connections, disconnect the power supply by
removing the fuse box.
3. Connect the power wire to one of the extra terminals of the fuse box.
4. Connect the black ground wire to a metal part of the car. It is important
to make good contact.
5. Make other wiring connections as shown.
6. Replace the fuse in the purple power lead wire.
NOTE: INCORRECT WIRING OR OPERATION WILL VOID THE
WARRANTY OF THIS UNIT.
WARNING: THE ISO CONNECTOR MUST NOT BE CUT.
Page 10
Page 11