Dry Ironing; Steam Ironing - Sunbeam Classic Iron 3964 Manual De Instrucciones

T F W
O ILL THE
1. Make sure the iron is unplugged. Set the Steam Lever to
Fabric Select Slide to OFF.
2. Lift the Water Fill Hole Cover.
3. Fill water cup with water. Pour water into iron water reservoir. Do not fill water
reservoir beyond maximum fill level.
W : To prevent the risk of burns, be careful when filling a hot iron with water.
ARNING
Hot metal parts, hot water and steam can cause injuries.
D I
RY RONING
1. Make sure the Steam Lever is turned to the
2. Plug the cord into a 120-Volt AC outlet.
3. Select the fabric setting you desire using the slide (Silk or Synthetics). Allow the iron
to heat for 2 minutes. While the iron is heating, make sure it is sitting on its heel rest
on a stable, protected surface.
N : While the Steam Lever is turned to the
OTE
the SHOT OF STEAM
is 1/4 full of water.
T : Refer to the Ironing Guide for the recommended setting for your fabric.
IP
S I
TEAM RONING
1. Make sure the Steam Lever is turned to the
necessary for Irons with the Drip Free™ feature)
2. Follow the instructions for "Filling the Water Reservoir".
3. Plug the cord into a 120-Volt AC outlet.
4. Select the fabric setting you desire using the slide (Synthetic, Silk, Linen,
Cotton or Wool). Allow the iron to heat for 2 minutes. While the iron is heating,
make sure it is sitting on its heel rest on a stable, protected surface.
5. Allow the iron to heat for 2 minutes, and then turn the Steam lever to the appropriate
setting.
T : Refer to the Ironing Guide for the recommended setting for your fabric.
IP
I : When not ironing, always set the Steam Lever to
MPORTANT
Fabric Slide to OFF.
All manuals and user guides at all-guides.com
R
ATER ESERVOIR
®
or SPRAY MIST
O
/Off (Dry) setting.
O /Off (Dry) setting, you may still use
®
feature. Please make sure the water reservoir
O /Off (Dry) setting. (This Step is not
O /Off (Dry) and the
O /Off (Dry) and the