Installation; Signal Pattern; Using Broadcast - Bellman & Symfon BE1481 Manual Del Usuario

Installation

Setting up the smoke alarm
1 Remove the mounting bracket from the smoke alarm by turning it counter-clock-
wise. Insert the supplied batteries to start the unit.
2 Fix the mounting bracket to the ceiling using the screws and plugs. Make sure
it's located at least 50 cm, (20") from walls and other obstructions, see
and positioning.
3 Fit the smoke alarm to the bracket by turning it clockwise until is snaps into place.
1 2
Testing the connection
1 Press and hold the smoke alarm test button
until the alarm sounds and the status
indicator starts to blink. The smoke alarm
transmits a radio signal to the receiver.
2 The red Visit LED on the receiver lights up
to show that the signal was received. In
addition, it starts to sound, flash or vibrate
depending on the receiver.
The smoke alarm will stop sounding shortly after the button is
released and the Visit receiver will time out in less than a minute.
10
Location
3
1 2

Signal pattern

The smoke alarm status indicator blinks in red once every 50 s to show that it is working
correctly. Depending on the cause of the alarm, the signal patterns are as follows:
Cause Sound
Activated by smoke

Activated by heat

Low battery Chirp every 50 s

Faulty unit Chirp every 50 s

When the low battery warning occurs for the first time, you have at least 30 days to
replace it. You can press the test button to temporarily hush the low battery warning for
10 hours.

Using broadcast

If you want the smoke alarm signal to be transmitted to all Visit receivers within radio
range, you can activate broadcast mode. This will override the radio key settings.
To activate broadcast, press the smoke alarm test button three times in quick succession.
The smoke alarm chirps and blinks three times to show that broadcast mode is activated.
Low battery warnings and alarm tests using the test button, will only be transmitted
to receivers with the same radio key.
To disable broadcast, press the smoke alarm test button three times in quick succession.
The smoke alarm emits a steady sound and light for 2 seconds. The smoke alarm has now
returned to the latest stored radio key.
Silence mode
If you experience nuisance alarms, press and hold the test button for 2 s to temporarily
silence the alarm. The status LED blinks every 16 s to show that the alarm is silenced.
The silence mode will automatically time out in 10 minutes.
Status indicator Visit receiver
Rapid flashing Fire alarm
Rapid flashing Fire alarm
Blink every 50 s Blinking red LED
Blink every 50 s –
EN
11