JB Systems SPACE COLOR Laser Manual De Instrucciones página 4

ENGLISH
LASER SAFETY INSTRUCTIONS:
 According to the EN 60825-1:1994 + A1:2002 + A2:2002 regulations, this laser falls
under the classification 3B. Direct eye exposure can be dangerous.
DANGER: LASER RADIATION !
Avoid direct eye exposure! Laser radiation can cause eye damage
and/or skin damage. All protective measures for a safe operation of
this laser must be applied.
 This product is a so-called show laser, emitting radiation with a wavelength spectrum
between 400 and 700 nm and producing lighting effects for shows.
 Due to the construction of this laser, the beam is moved so fast, that it can only hit the
eye very short. This is why the use of this laser for a Laser-Light-Show can be regarded
as save.
 Never direct the laser beam to people or animals and never leave this device running
unattended.
 This laser may only be used for shows. The operation of a class 3B show laser is only
allowed if the operation is controlled by a skilled and well-trained operator.
 Depending on the classification, operating a laser product can produce laser radiation
that may cause permanent eye damage and/or skin damage. The legal instructions for
using a laser product vary from country to country. The user must always inform himself
on the legal instructions valid in his country and apply them to his situation.
Please note that JB SYSTEMS cannot be made liable for damages caused by incorrect
installations and unskilled operation!
DESCRIPTION:
1. MAINS INPUT: with IEC socket and integrated fuse holder and power switch, connect
the supplied mains cable here.
2. ON/OFF KEY ACTUATED SWITCH: used to switch the unit on/off. Use the keys to
make sure only a skilled operator is able to switch the laser on.
JB SYSTEMS®
USER MANUAL
3/52 SPACE-COLOR Laser
ENGLISH
3. INTERLOCK input: used to connect the optional
emergency stop switch (see picture). When you push
this switch the laser beam
immediately.
IMPORTANT! For your own safety we strongly
recommend to connect this optional switch!
4. INTERNAL MICROPHONE: The built-in microphone
is used to synchronize the laser show to the beat of
the music.
5. DMX INPUT: 3pin male XLR-connector used to connect universal DMX-cables. This
input receives instructions from a DMX-controller.
6. DMX OUTPUT: 3pin female XLR-connector used to connect the Space Color laser
with the next unit in the DMX chain.
7. DISPLAY: shows the selected DMX address when the unit is in DMX-mode. Shows 3
horizontal lines when the unit is in stand-alone mode.
8. DIP-SWITCHES: switches 1~8 are used to set the DMX address between 000 and
255. Switch 9 is not used and switch 10 is used to select stand-alone or DMX mode.
9. AUTO/MUSIC SWITCH: when the unit is used in stand-alone mode, this switch sets
the laser in music mode (patterns move to the rhythm of the beat) or auto mode
(patterns move automatically)
10. SAFETY EYE: used to attach a safety cable when the unit is rigged (see paragraph
"overhead rigging"
11. MUSIC INPUT SENSITIVITY: This potentiometer is used to adjust the music input
sensitivity. Turn the potentiometer until the laser works in sync with the music.
12. COOLING FAN: used to cool the components inside the enclosure. Make sure to
never cover this fan outlet!
13. POWER LED: indicates that the unit is switched on.
14. SOUND LED: flashes to the sound of the music detected by the internal microphone.
15. HANGING BRACKET: with 2 knobs on both sides to fasten the unit and a mounting
hole to fix a mounting hook.
JB SYSTEMS®
USER MANUAL
will disappear
4/52 SPACE-COLOR Laser