Canceling A Cycle; Changing A Cycle Or Setting; Adding Items During A Cycle; Option Selections - Sears Kenmore ELITE 665.15912 Manual De Uso Y Cuidado

Use this cycle for pre-
rinsed or lightly-soiled
loads. This cycle
automatically adds a fill
and brief pre-wash,
purging the hot water line
and improving wash
results, without adding
time for water heating
periods.
Initial display time: 48 min
First Fill Wash Main Rinse
Water Wash
Temp.
Greater
than
135°F
(57°C)
Less
than
135°F
(57°C)
Use this rinse cycle for
rinsing dishes, glasses,
and silverware that will
not be washed right
away.
Initial display time: 10
min
Wash Main Rinse Rinse
Wash
NOTE: The sensor in your dishwasher monitors the soil level.
Cycle time and/or water usage can vary from the numbers above
as the sensor adjusts the cycle for the best wash performance.

Canceling a Cycle

Anytime during a cycle, press
The display shows
Your dishwasher starts a 2 minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light turns
off. Select a new cycle and options.
To stop the drain
You can press Cancel/Drain again to stop the drain immediately.
Remember to drain the dishwasher before starting a new cycle.
To clear the indicators
Press Cancel/Drain before starting the dishwasher to clear all
options and cycles.
14
Use main detergent
dispenser section.
Rinse Final Dry Time
Heated (min)
Rinse
48*
44*
Do not use detergent
with this cycle.
Final Dry Time
Heated (min)
Rinse
10

Changing a Cycle or Setting

During the first fill of a cycle
1. Press a new cycle and/or options.
2. Check the detergent dispensers. They must be filled properly
for the new cycle.
After the first fill of a cycle
1. Press
Water
Usage
(gal/L)
5.2-6.7/
19.7-25.4
The display shows
6.9-8.4/
26.1-31.8
Your dishwasher starts a 2 minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light
turns off.
2. Check the detergent dispensers. They must be filled properly
Water
for the new cycle.
Usage
(gal/L)
3. Close the door.
1.8-2.1/
4. Press a new cycle and/or options.
6.8-7.9
5. Press START.

Adding Items During a Cycle

You can add an item anytime before the main wash starts. Open
the door and check the detergent dispenser. If the cover is still
closed, you can add items.
To add items
1. Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.
2. Open the door. If the detergent dispenser cover is still closed,
add the item.
3. Close the door firmly until it latches. The dishwasher resumes
the cycle after about a 5 second pause.
You can customize your cycles by pressing an option. If you
change your mind, press the option again to turn the option off,
or select a different option if desired.
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
any time before drying begins.
Press START to use the same cycle and option(s) as the previous
wash cycle.
NOTE: If the last cycle you completed was a rinse cycle, when
you press Start, the dishwasher runs the last full wash cycle and
options.

Option Selections