To Set The Clock; Unpacking And Installation - Gear4 CDB-50 Manual Del Usuario

Plug a 3.5mm audio cable (not included)
■
into your MP3 or MP4 player and connect
the other end into the AUX port at the back
of the unit.
Press play on your MP3 or MP4 player.
■
N.B. The remote will not control devices
connected via 3.5mm cable.

To set the clock:

In standby mode press and hold the CLK
■
SET button on the speaker or remote control
and select either 24 hour or 12 hour using
/ buttons (press CLK SET to save).
The hour display will start flashing, press
■
on the speaker or remote control to
/
adjust the hour (press CLK SET to save).
The minute display will start flashing, press
■
/ on the speaker or remote control to
adjust the minutes (press CLK SET to save).
WaRninG
To reduce the risk of fire or electric shock,
do not expose this unit to rain or moisture.
CaUTion
Use of controls or adjustments of performance
of procedures other than those specified may
result in hazardous radiation exposure.
9 GEAR4 | CDB-50 User Manual

UnPaCkinG anD insTallaTion

Unpack your unit carefully. We recommend that
you save the packaging in case you ever need
to store your unit. To avoid damage, never place
the unit or it's batteries near radiators, in front of
heating vents, under direct sunlight or near water.
FoR yoUR saFeTy
– When disconnecting the power adapter,
pull the power plug first. Do not pull the
cord by itself.
– Never handle the power plug with wet hands,
as this could cause fire or electric shock.
– Refer servicing to qualified personnel only.
– Replace the lithium remote control battery
with the same type to avoid risk of explosion
– Do not open the housing.
– Do not twist or pinch the power supply cord.
If the plug or power supply cord needs to be
replaced, ensure that it complies with the
manufacturer's recommendation.
– Only use GEAR4 approved accessories.
– Do not put anything except a compact disc
into the compartment. Other objects may
damage the unit.
– Unplug the unit during lightning storms and
when unused for extended periods of time.
– This product employs a Laser System. To
prevent direct exposure to laser beam, do not
try to open enclosure. Visible laser radiation
when open. DO NOT STARE INTO BEAM.