Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6
GH cross hanger
Caution!
Be careful when attaching the lifting sling's straps on the
hooks . Check that the straps have been correctly placed in
the lifting hanger's hooks . When pressing the up button on
the hand control to lift the user, check again that all straps
remain correctly placed in the lifting hanger's hooks (Fig. 1) .
Fig . 1
Placing the sling, look at page 28.
2 .00
Maintenance
2 .01
Cleaning
Normal washing at the indicated temperature
Do not use bleaching agent
Tumble-drying at low temperature
Do not iron
2 .02
The owner's daily maintenance duty
Check the lifting sling for wear and damage before use accord-
ing to the following checklist which is not intended to represent all
potential inspection steps. Potential damage may vary. Judgment
of inspector/site prevails.
Sling inspection checklist
Before using a Guldmann sling / accessory check the following:
Is the sling clean?
Follow facility specific infection control procedure.
Is the sling's label present, legible and complete?
Missing, illegible or incomplete sling label(s) could make identifica-
tion of appropriate size of the sling, function of sling, and or weight
limit capacity of the sling impossible.
Are the lifting straps and stitches intact?
•
Look for broken or worn stitches
•
Look for knots in straps
•
Look for tears or fraying of straps
•
Look for snags or punctures or holes
•
Look for any particles in fabric or straps
Is the fabric intact?
•
Look for abnormal wear patterns, excessive wear, abrasive
evidence
•
Look for cuts or frayed fabric
•
Look for unusual or significant discoloration
•
Look for snags, punctures, tears, holes
•
Look for frayed or insecure seams
•
Look for any acid / caustic / thermal burns
•
Look for changes in material consistency, e.g. increased
stiffness
•
Look for any imbedded particles
Are slings the original size and length without the use of
knots, pins, tape or other methods to change the shape,
shorten or lengthen them?
All manuals and user guides at all-guides.com
Conclusion
If the sling suffers from one or more of the above mentioned
conditions then it must be taken out of service regardless of the
weight of the person to be lifted.
2 .03
Slings are disposed of by incineration. By proper incineration
polyester will be degraded to carbon dioxide and water.
3 .00
3 .01
In accordance with international standard EN/ISO 10535 "Hoist for
the transfer of disabled persons – Requirements and test meth-
ods" an inspection must be performed every 6-month according
to the following instructions, which is not intended to represent all
potential inspection steps. Potential damage may vary. Judgment
of inspector/site prevails.
Safe Operating Practices with Slings
Considerations for damaged or defective slings and taking them
out of service:
Withdraw the sling from service if one or more of the following
conditions are present:
•
•
•
•
•
•
•
•
Sling inspection is done for the protection of the user, the caregiv-
er, and the overall hospital site safety. A sling inspection system
has additional benefit. Systematic sling inspection will assist in the
identification of damage trends, potentially leading to cost effective
suggestions and results. The inspection process can also help to
identify inventory duplicity in certain sling types and sizes.
Sling inspection system
Development of a specific procedure and program for the inspec-
tion of slings at your facility is your best safeguard. Consider em-
ploying a three part system of inspection. Slings that are removed
from service and are not capable of repair should be disposed of
so they are unfit for any future use and can not find a way back
into active inventory.
1) Initial
This level of inspection is done at the time that the sling is re-
ceived into your facility. The inspector should ensure that no dam-
age has occurred during transit, and also verify that the sling work
load limits match those contained in the manufacturer's catalogue.
If your facility documents the sling inspection process through writ-
ten inspection records, the paper trail should begin at this stage.
2) Frequent
The frequent level of inspection should be done by the sling user
before each use. The sling should be examined and removed
from service if damage is detected. The sling user should also
determine that the sling is proper for the user conditions, care task
required and the required weight capacity.
3) Periodic
Your facility might want to consider implementing a program for a
periodic level of inspection at regular intervals. The interval should
be based upon the frequency of use, severity of the service cycle
and information derived through the inspection process. Recom-
mendations to prevent damage and enhance service life could
Disposal of slings
Service and lifetime
Safety/service inspections
chemical or caustic burns
melting or charring of any part of the sling
snags, punctures, tears or cuts
broken or worn stitches
missing, illegible or incomplete sling tag
knots in any part of the sling
abrasion
other visible damage that causes doubt as
to the strength of the sling
Publicidad
Tabla de contenido
