Safety Instructions - Brevi WALLY Instrucciones De Uso

your purchase.
ASSEMBLY INSTRUCTIONS
1. Assemble the wheels (B) on the foot-board (A) with the screws
(C) and nuts (D). Ensure that the screws are firmly tightened.
Use the attached tool for this and the further steps.
2. The coupling part (F) of board is provided with 4 pairs of adap-
tors that fit most of the baby carriages at the rear part for 10
mm axel (folding pate) or tubes of 25,4, 17 and 45 mm dia-
meters. Assemble the fitting pairs of adaptor in the coupling
wire by pulling and hold the trigger as illustrated and sliding the
adaptor up into the coupling wire at both sides.
3. The coupling part (F) has already been pre-assembled by the
manufacturer as per the following drawing (pic.4). If the stroller
is equipped with a basket, it can be of help if the basket is re-
moved so that sufficient space can be created for the coupling
hooks.
4. Measure the axle height of your pram. Screw connect the L-
attachment (M) provisionally with the coupling plate (pic.8),
depending on the axle height with the L-attachment upwards
or downwards (see pic.5).
5. Assemble the foot-board (A) on the L-attachment (M) using the
screws (P), washers and nuts (L-I). Hang the coupling set onto
the stroller axle with both hooks. Alter the height on the L-bar
(M) by selecting the corresponding hole height until the board
is positioned horizontally to the ground. The foot-board is po-
sitioned horizontally at a height of 16 cm above the ground.
6. Now adapt the coupling parts (pic.10) to the pram axle as far as
the greatest possible width. Fix all screws in this position. Your
board is now ready for use.

SAFETY INSTRUCTIONS

WARNING Never leave your child unattended.
WARNING Ensure that all the locking devices are
engaged before use.
WARNING Any load attached to the handle and/or
on the back of the backrest and/or on the sides of
the vehicle will affect the stability of the vehicle.
WARNING This product is not suitable for running
or skating.
WARNING The board is designed for children from
15 months and up to a maximum weight of 20 kgs.
ATTENTION Remove the footboard before folding
and before stopping the stroller.
Do not use the board until your child can walk independently and
without help. Children must only be transported on the foot-board
in a standing position. Allow your child to alight from the board be-
fore reaching pavement edges, stairs, steep paths, tight corners,
as well as when manoeuvring backwards. There may be types
of pram for which the board is not suitable because the coupling
cannot be attached firmly to the frame construction. Consult your
specialist dealer before making your purchase. Before starting
out on each journey, check whether board and pram are correctly
connected to one another. From time to time, check that all screws
and mountings of the board are sitting firmly and that all parts
700-02-160404-00 istruzioni WALLY.indd 7
All manuals and user guides at all-guides.com
of the pram are OK. No alterations must be made to the board
or pram which result in safety no longer being guaranteed. The
board is not suitable for use on snow or soft surfaces. Clean the
board and the wheels from time to time with warm soapy water.
Apart from this, adhere precisely to the instructions of your pram
manufacturer. The use of the board is only admissible if there is
a second child in the pram or if the pushing handles of the pram
are held tightly with both hands by an adult. The board is not a toy.
In order to guarantee the safety and functionality of the device,
avoid any overloading and under no circumstances use it for tran-
sporting other items.
Accesories which are not approved by Brevi srl, shall not be used.
Warning. To avoid suffocation risk, remove the plastic protec-
tion before using the product. This plastic protection has to be
thrown away in a waste disposal far from the child.
WICHTIG - Heben sie diese Anwei-
sungen für künftiges Nachschlagen
auf.
Geschätzte Kundin, wir danken Ihnen für die Wahl eines Produkts
von Brevi.
Dieses Fuβboard ist eine bequeme Mitfahrgelegenheit für Ihre
Kinder. Wally Fuβboard ist ein praktisches Produkt, das man an
die Rückseite fast aller Kinder-und Sportwagen befestigen kann.
Es ist geeignet für Kinder- und Sportwagen mit
Achse, Traverse oder Rohr mit einem Durchmes-
ser bis max. 45 mm. Nicht geeignet für Kinder-
oder Sportwagen ohne Rückhalterung zur Befe-
stigung des Fußboards oder deren Bremse die
Befestigung behindert. Bitte lassen Sie sich bei
Ihrem Fachhändler beraten.
ANLEITUNG
1. Die Räder (B) an das Fuβboard (A) mit Schrauben (C) und
2. Anbei finden Sie 4 Paar Adapter, mit denen die Fuβboard-
3. Die Halterung (F) wird bereits montiert geliefert (siehe Bild 4).
4. Die Höhe der Rücktraverse abmessen und das Winkeldreieck
DEUTSCH
Schraubenmutter (D) montieren. Bitte vergewissern Sie sich,
dass die Schrauben richtig festgezogen sind. Bitte verwenden
Sie das mitgelieferte Werkzeug auch für die nächsten Monta-
geschritte.
Halterung (F) einfach, an fast alle Kinder- und Sportwagen mit
flacher Rücktraverse bis 10 mm oder Achse/Rohr mit Durch-
messer bis max. 45 mm,17 zu befestigen ist. Die Adapter müs-
sen beidseitig montiert werden: die Feder drücken und halten,
dann die Adapter in die Haltung einstecken.
Wenn der Korb des Kinderwagens die Montage des Fussboard
hindert, bitte entfernen Sie ihn.
7
04/04/2016 15.29.06