Publicidad
Idiomas disponibles
Idiomas disponibles
Step 1: Place the Bass Drum (1) flat on the floor
to attach the heads (2) and hoops (3). Place one
of the colored hoops (3) over the top of the drum
head so that the head is sandwiched between the
hoop and the shell. Bass tension rods (4) are
longer in length than floor tom rods and tom tom
rods. And you need to put a white washer on
them. Place them thru the claw hooks, then place
the claw hooks on the hoop (3) straight in line
with bass drum lug. Hand tighten the tension rod
with drum key (28) into the lug; repeat all the
way around the drum.
Step 2: Insert one bass drum spur (5) on each
side and push it fully into the leg bracket and
lightly tighten the wing nut on bass drum to stop
the leg from falling out; repeat the other spur on
the drum.
Step 3: Insert the cymbal holder (25) into the
hole. Tension the T-rod.
Fit the pedal (6) to the hoop by slipping it over
the trailing edge of the hoop and tightening the
wing nut that is underneath the footplate. The
beater should be pushed into the pedal and
tightened so that the beater strikes the drum head
near its centre.
04
Publicidad
