Basic Opera�On; Lndicator Light And Lightsenor; Indicator Light - LC-POWER LC-M27-QHD-240-C-K Manual Del Usuario

7. Basic Opera�on
Plug one end of the DisplayPort (DP) cable into the graphics card of the
PC. For convenience, a DP cable and an HDMI cable are included. You can
also use an HDMI cable.
1. Connect the other end of the cable to the corresponding connector on
your monitor.
2. Connect the power cable to your monitor then connect the other end to
your power source. It is recommended that you use a surge protector with
adequate voltage if a wall outlet cannot be reached directly.
3. Locate the power bu�on on the monitor and press it to turn the monitor
on.
8. lndicator Light and Light Senor

Indicator Light

— Indicator Light Solid blue light indicates power is on and the monitor is
opera�ng normally. Flashing blue and red light indicates no video souce, no
horizontal/ver�cal signal has been detected or Voltage is low. Solid red light
indicates power is off.Please ensure your computer is on and all video cables
are fully connected.
— Light Senor: When the light sensor is turned on, the screen brightness
changes with the ambient light, and the brighter the ambient light, the
brighter the screen. When the light sensor is turned off, return to the user's
original brightness se�ng
USB A Ports USB A Ports
DC USB-A USB-A USB-B
Power Connector
HDMI 2 HDMI 1 DP
HDMI 2.0 Ports DP 1.4 Ports
Eng-7
Audio Out
Type-C AUDIO
Type-C Ports
Light Senor