Clothing And Equipment; Transporting The Machine; Before Starting Work - Stihl HTE 60 Manual De Instrucciones

English
Use only high quality parts and accessories. In
order to avoid the risk of accidents and damage
to the machine.
STIHL recommends the use of STIHL original
tools, guide bars, saw chains, chain sprockets
and accessories. They are specifically designed
to match the product and meet your performance
requirements.
Never attempt to modify your power tool in any
way since this may increase the risk of personal
injury. STIHL excludes all liability for personal
injury and damage to property caused while
using unauthorized attachments.
Do not use a high-pressure washer to clean the
power tool. The solid jet of water may damage
parts of the unit.
Do not spray the power tool with water.
Unsuitable extension cords may be dangerous.
Make sure that the conductor cross section (wire
gauge) of extension cords meets the minimum
requirements – see chapter on "Starting".
2.1

Clothing and equipment

Wear proper protective clothing and equipment.
Clothing must be sturdy but allow
complete freedom of movement.
Wear snug-fitting clothing with cut
retardant inserts – an overall and
jacket combination, do not wear a
work coat.
Do not wear clothing which could
become trapped in wood, brush or
moving parts of the machine. Do not
wear a scarf, necktie or jewelry. Tie
up and confine long hair above your
shoulders.
Wear cut protection safety boots with
non-slip soles and steel toe caps.
WARNING
To reduce the risk of eye injuries,
wear close-fitting safety glasses in
accordance with European Standard
EN 166. Make sure the safety
glasses are a snug fit.
Wear "personal" sound protection, e.g. ear
defenders.
Wear a safety hard hat where there is a danger
of head injuries from falling objects.
28
2 Safety Precautions and Working Techniques
Wear sturdy protective gloves made
of a resistant material (e. g. leather).
STIHL can supply a comprehensive range of per‐
sonal protective equipment.
2.2

Transporting the machine

Always stop the engine.
Always fit the chain scabbard – even when you
carry the power tool for short distances.
Ensure that the power tool is always well bal‐
anced and hold it by the shaft for carrying.
Transporting by vehicle: Properly secure the
power tool to prevent turnover and damage.
2.3

Before starting work

Check that your power tool is properly assem‐
bled and in good condition – refer to appropriate
chapters in the User Manual:
– Correctly mounted guide bar
– Correctly tensioned saw chain
– Never attempt to modify the controls or safety
devices
– Keep the handles dry and clean – free from oil
and dirt – this is important for safe control of
the machine
Voltage and frequency of the machine (see rat‐
ing plate) and the voltage and frequency of your
power supply must be the same.
The wall outlet must be equipped with a ground
fault interrupter or such a device must be instal‐
led in the circuit when operating the electric pole
pruner outdoors. Contact an electrician for fur‐
ther information.
The power supply cord, mains plug and switch
and extension cord are particularly important.
Never use damaged cords and plugs or connect‐
ing cords that do not comply with regulations.
0458-247-9921-C