Datamax W-6208 Manual Del Usuario página 23

Ribbon Loading
Upper Ribbon Rollers
Lower Ribbon Rollers
Ribbon Take-up Hub
Platen Roller
Ribbon Supply Hub
Ribbon
J-Hook
1. Open the cover. Unlatch and raise the printhead.
2. Slide a roll of ribbon onto the ribbon supply hub. Push the ribbon
all the way back until it stops.
3. Route the ribbon from the ribbon supply hub under the lower
ribbon roller, and over the platen roller. Lower the printhead and
bring the ribbon up and over the upper ribbon rollers, then pull the
ribbon back and underneath the ribbon take-up hub.
1. While holding the ribbon take-up hub, rotate the J-Hook
counterclockwise to un-latch.
2. Raise the J-Hook upward and place the end of the ribbon over the
ribbon take-up hub.
3. Lower the J-Hook and rotate it clockwise to latch.
4. Rotate the ribbon take-up hub several turns counterclockwise to
remove any slack in the ribbon.
5. Lower and latch the printhead.
6. Close the cover.
All manuals and user guides at all-guides.com
13