DURABLE 3702 Manual Del Usuario página 21

▶ see figure 3
– Fasten the castors (7/8) cross-wise on the base plates (6).
▶ see figure 4
– First remove the lower and then the upper panel of the profile (4).
▶ see figure 5
– Place the body (5) with the front edge and the foot-cross on the floor. Fasten the profile (4)
on the body (5) using the M6×12 31491 screws.
▶ see figure 6
– Insert the handle (1) in the profile (4) and fasten it using the M6×16 35696 screws.
Fixing the monitoring brackets and the monitors
Note:
Computer, monitor and cables are not included in the scope of delivery.
Note:
Depending on the VESA hole dimension of your monitor/TV, you must use the provid-
ed wing to fix the monitor.
▶ see figure 7
– Pull at the fastening tape (9) to remove the VESA plate (10) from the monitor bracket (3).
▶ see figure 8
– Lay the monitor (11) on a flat surface with the display facing downwards. Place a cover or
similar under it for protection.
– Remove any coverings in the mount area of the VESA plate (10) on the monitor. Consult the
monitor manufacturer's operating instructions.
– Look for the fastening holes of the monitor and, if necessary, attach the wing (12) on the
VESA plate (10).
– Fasten the wing (12) and/or the VESA plate (10) on the monitor (11) using the provided
screws and spacers (G-J).
– Use only the matching screw lengths to prevent the device from getting damaged.
▶ see figure 9
– Pull down the fastening tape (9) and cut it to the desired length.
▶ see figure 10
– Loosen the screws (13) slightly to adjust the height of the monitor bracket. Ensure that the
monitor bracket is horizontal. Tighten the screws (13) again.
▶ see figure 11
– Fix the monitor (11) on the monitor bracket (3).
▶ see figure 12
– Equip the video cart with suitable accessories and required cables.
– The cables leading towards and away from the monitor can be laid in the rear profile.
– Ensure that the cables are at the centre of the profile and are not pinched.
▶ see figure 13
– Close the profile (4) with the lower and upper panels.
Fixing the keyboard panel
▶ see figure 14
– Bring the keyboard panel (14) to the desired height such that you can close the cover of the
body (5) when the keyboard is pushed in and still be able to grab it.
EN
English
| 21 | 19