Top View - Craftmade Triumph Manual Del Usuario

1
Step 1 - Downrod Option
Prior to securing Mounting Bracket/Plate, screw "J" Hook (S8) into
Ceiling Outlet Box as a secondary support means. Secure Mounting Plate
(1A) and Mounting Bracket (1B) to the outlet box (A) by tightening
bracket screws & washers (S3) as shown. If not mounting to an Outlet
Box, use Wood Screws (S1) and Washers (S1) and mount securely to
Ceiling Beam.
NOTE: Do not mount directly to sheet rock or ceiling tile.
NOTE: "J" Hook installation is a Canadian requirement only.
"J" Hook (S8)
OUTLET BOX
Ceiling
Ground Wire
Bracket Screws
& Washers (S3)
Wood Screw (S1)
Helpful Hint
Remove fan motor (#4) from inside the box, turn the top foam insert
upside down, then lay the fan motor face down into the foam. This
will hold the motor housing steady during assembly.
All manuals and user guides at all-guides.com
Support Beam
Outlet Box (A)
Mounting Plate (1A)
Mounting Bracket (1B)
Wood Screw (S1)
2
Step 2 - Blade Assembly
Take out the four screws in the Top Motor Housing (#4). Save the
screws. Raise the Top Motor Housing (#4) off the base (see figure 1).
Slide blade (#5) through slot on side of fan. Attach with Blade Screws
(S4) as shown in figure 2. Repeat this procedure until all five blades are
secured. Tighten firmly. Reattach Antenna wires, then reattach Top
Motor Housing (#4).
Figure 1
Figure 2
Blade (#5)
Top Motor Housing (#4)
Antenna Wires
Motor Housing (#4)
Blade Screws (S4)

Top View

CAUTION: Never hold or lift fan by blades