Craftmade Triumph Manual Del Usuario página 5

3
Step 3 - Standard Down Rod Assembly (Steps 3-7)
Locate Downrod Assembly (#2). Loosen Ball Screw on black Hanging
Ball to free lock pin. Black Hanging Ball will slide down. Remove
Ground Screw and green Ground Wire. Remove Hanging Ball from
Downrod and save all parts. Insert fan wires through Downrod. Screw
Downrod into top of Fan Motor Housing, being careful that wires are
pulled through.
Lock Pin
Downrod
Assembly
(#2)
All manuals and user guides at all-guides.com
Green Ground
Wire
Canopy
Ball Screw
Hanging Ball
Downrod
Canopy Decorative Cover
Flange Cover
Fan Motor Housing
4
Step 4
Position Downrod so the hole in the Downrod aligns with the hole in
the Flange Coupling on the Motor. Insert Safety Bolt (S7) through
Coupling and Downrod and attach Nut. Tighten firmly. Tighten
Set Screw "A" against downrod. Place Flange Cover (#10) and
Canopy Decorative Cover (#11) and Canopy over Downrod
Assembly. Replace Hanging Ball, insert Hanging Pin through
Downrod and tighten Set Screw "C" in Hanging Ball into Downrod.
Threaded Set
Screw Hole
Ground
Wire
Hanging
Pin
Ball Screw
Hanging
Ball
Set Screw (A)
Safety Bolt & Nut (S7)
WARNING:
Failure to completely tighten downrod could result in the fan loosening
and possibly falling.
IMPORTANT: Black antenna wire must be connected for remote to function.
Safety Cable (Canada)
Set Screw (C)
Downrod (2)
Canopy (3)
Canopy Decorative
Cover (11)
Flange Cover (10)
Top Motor Housing (4)
Motor Housing (5)