How To Operate The Audio Control; Switching Audio Control Modes - Fujitsu Ten ECLIPSE CD2000 Manual Del Propietário

Tabla de contenido

Idiomas disponibles

How to operate the AUDIO CONTROL

Switching audio control modes

Various audio control modes may be fine-tuned using this procedure.

Press the [AUDIO CONTROL] button for less than one second to select the item

to be adjusted.

Modes will switch in the order shown below each time the button is pressed.

VOL ➔ BASS ➔ MID ➔ TREB ➔ BAL ➔ FAD ➔ NON-F ➔ NF-P ➔ LOUD ➔ VOL

ATTENTION

Press the [MUTE] button for less than one second to cut the volume or restore it instantly.

WARNING

Do not adjust the volume or other controls while driving the vehicle. Do so only while parked in a

safe location.

Mode

VOL (VOLUME)

BASS

MID (MIDDLE)

TREB (TREBLE)

BAL (BALANCE)

FAD (FADER)

NON-F (NON-FADER)

NF-P (NON-FADER

PHASE)

LOUD

All manuals and user guides at all-guides.com

Function

Adjusts volume.

Adjusts bass level. Bass mode can be

adjusted for each source

(CDP/CDC, FM ,AM).

Adjusts middle level. Mid mode can be

adjusted for each source

(CDP/CDC, FM , AM).

Adjusts treble level. Treble mode can be

adjusted for each source

(CDP/CDC, FM , AM).

Adjusts left/right speaker balance.

Adjusts front/rear speaker balance.

Adjusts non-fader level (for connected

sub-woofers, etc.).

The merging of sound between the front

and rear speakers and the woofer can be

improved by selecting the phase.Switch

the phase to a phase which lets the

speakers combine without any

disharmony.

The loudness control may be turned on to

emphasize low and high frequencies at

low volume levels.

Loudness compensates for the apparent

weakness of low and high frequencies at

low volume by boosting the bass and

treble levels.