Napa Carlyle tools 6-789A Manual Del Usuario página 5

OPERATION
Locate center of new hole by using a
center punch. Place drill bit tip in
punch mark. Hold drill square with
work and start motor. Apply steady,
even pressure. Do not force. Too
much pressure can cause bit to break
or overheat. Too little pressure will
keep the bit from cutting and cause it
to overheat. Reduce pressure just
before bit cuts through the work.
When bit has penetrated work and is
spinning freely, take it from the work
while the motor is running, then turn
off the drill. If the drill jams in the
work, release throttle immediately.
Disconnect the drill before removing
bit and determining cause of trouble.
WARRANTY
Important: DO NOT RETURN DEFECTIVE PRODUCT OUTSIDE OF ORIGINAL ONE (1) YEAR WARRANTY PERIOD TO
PLACE OF PURCHASE.
WARRANTY POLICY:
This Carlyle Air Tool is warranted against defects in material and workmanship for a period of One (1) Year
from the date of original purchase. We will replace, at our option, any part which proves to be defective in material or workman-
ship. Repairs or replacements are warranted as described above for the duration of the original warranty period. In the unlikely
event a replacement unit is required during this One (1) year period, return the unit to your local NAPA Auto Parts Store for a
replacement. This warranty does not apply to products which have been subjected to abuse, misuse, modification, neglect, lack of
maintenance, use in a production-related service, or repaired by anyone other than an Authorized Carlyle Air Tool Service Center.
For complete listing of Authorized Master Repair Centers, see enclosed Customer Warranty Repair Form, or
visit www.toolwarrantyrepair.com
PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE THIS MAN U AL FOR FUTURE REF ER ENCE.
6-789A
All manuals and user guides at all-guides.com
Do not attempt to free the bit by
starting and stopping the moto.
Drill bits can bind suddenly and caus-
ing rotation of the work piece or tool,
causing injury to arms and/or shoul-
ders. Enough torque is generated to
cause falls. Always use sharp bits.
Use less downward pressure at
breakthrough.
Never use dull, chipped or damaged
accessories. Never cool a hot
accessory in water as brittleness
and early failure can result, Accessory
breakage or tool damage may result
from prying. Take smaller bites to
avoid getting stuck.
5
Specifications
Horsepower...............................0.5HP
Max. Free Speed .............. 1,800 RPM
Chuck Cap .................................. 3/8"
Spindle Thread .......................3/8"-24
Air Inlet ............................... 1/4" NPT
Min. Hose Size .....................3/8" I.D.
Avg. Air Cons. ........................ 4 CFM
Recom. Air
Pressure ................. 90 PSIG (6.2 bar)
Vibration level .....................2.29 m/s2
Weight .................................... 2.6 lbs.
Length ............................................ 7"
Sound Level ........................ 90.6 dBA
Rev. 08/29/19