Antec New Solution Serie Manual Del Usuario página 7

Note: We recommend using the lower drive tray (the one at the bottom of the case
) as it will provide better cooling and cable management. Using the HDD bay at the
bottom of the case may result in being unable to use the 4th PCI slot depending
on the length of the card used.
5. Find a 4-pin Molex connector on the power supply and connect it to the male
4-pin connector on the device.
5.25" Device Installation
There are two external 5.25" drive bays (with one HDD tray inside the lower
5.25" bay). Note: If you choose to use the lower drive bay for the HDD, you can
only install one 5.25" device to the case.
1. Looking from the rear of the case you can see some metal grilles covering the
5.25" drive bays. Carefully push a screwdriver through the metal grille and
gently push the plastic drive bay cover outwards until it comes off.
2. Use your hands to twist the metal plate back and forth until it breaks off.
Be careful of the newly exposed metal where the grille was attached, as these
areas are likely to be sharp. Note: Don't break off the metal grilles covering the
drive bays that you are not using now
3. Slide the 5.25" device into the bay from the front.
4. Fasten the 5.25" device into the drive bay with screws provided.
5. Repeat the same procedure for other devices.
6. Connect a 4-pin large white connector from the power supply to the male 4-pin
connector on each of the devices.
Cooling System
The Rear Exhaust TriCool™ fan:
The NSK 3400 comes with one 120mm TriCool™ fan preinstalled. This fan has a
three-speed switch that lets you choose between quiet, performance, or maximum
cooling. (See specifications below.) The fan is installed so that the air is blowing
out of the case. Connect a large 4-pin connector from the power supply to the
male 4-pin connector on the fan. Note: The default setting of the fan is Low. We
recommend this speed to maximize quiet computing.
Note regarding fan speed controllers: The minimum voltage to start the fan is 5V.
We recommend setting the fan speed to High if the fan will be connected to a fan
control device or to the Fan-Only connector found on some of Antec's power
supplies. A fan-control device regulates the fan speed by varying the voltage to it.
The voltage may start as low as 4.5V to 5V. Connecting a TriCool™ set on
Medium or Low to a fan-control device may result in the fan not being able to
start. The already lowered voltage from the fan control device will be further
reduced by the TriCool™ circuitry below 5V.
All manuals and user guides at all-guides.com
5