Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
heater.
The display (I) will turn on, showing the current temperature (c), time (k) and day of the
•
week (n).
•
Each time the heater is connected to the mains, the time and day of the week must
be set.
•
The default heater settings are: time - "12:30", day of the week - "7" (Sunday), temperature
- "20°C".
Setting the time and day of the week (setting is possible only using the control panel (1))
•
Turn on the heater.
Press and hold the (VI) button on the control panel for approx. 3s - the hour field on the
•
display (I) will start flashing.
•
Press the (+) or (-) buttons to set the hours.
•
Press and hold the (VI) button for approx. 3s again - the minute field starts flashing.
Press the (+) or (-) to set the minutes.
•
Press and hold the (VI) button for approx. 3s again - the day of the week indicator (n)
•
will start flashing.
Set the day of the week using the (+) and (-) buttons. Digits "1" - "7" in field (n) indicate
•
days of the week, from Monday to Sunday.
•
Wait approx. 5s until the day of the week indicator (n) stops flashing.
Temperature setting (using the control panel (1) and the remote control (7))
•
When the heater is switched on, the default set temperature is 20°C.
The temperature can be changed using the (+) and (-) buttons.
•
•
Air temperature can be set in the range of 10-49°C;
•
Once the temperature is selected, digits in the (c) field will flash and the current ambient
temperature will be displayed after a moment.
Operating modes
The device can operate in three modes:
(f)
daytime – the appliance operates at full power
•
•
(g) night – the appliance operates at half power
•
(h) anti-frost - the unit turns the heating on when an ambient temperature lower than
5°C is detected, then the heater will automatically turn the heating on at half power and
continue to run until the room is heated to 9°C, then the heater is turned off.
Setting the operating mode (using the control panel (1) and the remote control (7))
•
After switching the heater on, select the operating mode using the (II) button.
•
To do this, press the (III) button until the corresponding indicator light on the display (I)
is illuminated.
"Window" function (using the control panel (1) and the remote control (7))
•
When this function is activated and if the ambient temperature drops 5 degrees over
10 minutes, the user is considered to have opened a window and the heater will stop
heating and enter standby mode.
17
Publicidad
Tabla de contenido
