Blower Operation; Vacuum Operation - Black and Decker BV2900 Manual De Instrucciones

OPERATION
alWaYs WEar saFETY glassEs. WEar a FilTEr MasK
iF ThE OPEraTiOn is DUsTY. UsE OF rUBBEr glOVEs
anD sUBsTanTial FOOTWEar is rECOMMEnDED WhEn
WOrKing OUTDOOrs. FOr hOUsEhOlD UsE OnlY.

WARNING:
tool off for tube installation or any other reason, wait 10
seconds for the fan to stop rotating before disassembly.

CAUTION:
Always switch off and remove
the plug from the electrical supply when:
• Changing from blower to vacuum.
• The power supply cord has become damaged or entangled.
• You leave blower/vac unattended.
• Clearing a blockage.
• Checking, adjusting, cleaning or working on blower/vac.
Use blower/vac only in daylight or good
artificial light.
Switching on and off (Figure G)

WARNING:
product firmly when switching on.
 WARNING:
for approximately 5 seconds after it has been switched
off. Use both hands to grip the tool and let the motor
come to a complete stop before setting the tool down.
Your blower vac is fitted with a two speed switch located on
the top of the handle.
• To use in low speed, slide the switch
Position 1. To use in high speed, fully slide the switch
forward to Position 2.
• To turn the tool off, slide the switch all the way back to
Position 0.
Figure G
Extension cord retainer
A cord retainer is incorporated into the rear of the power
head. It can be used in two different ways:
• To use the cord retainer as shown in figure H1, insert the
extension cord into the cord retainer housing from the
side. Loop the extension cord around the retainer so it
rests in the cord retainer. Then plug the cord from the
power head into the extension cord.
All manuals and user guides at all-guides.com
Cut Hazard. When turning the
Use both hands to grip the
The tool will continue to run
2 foward to
• To use the cord retainer as shown in figure H2, loop the
extension cord over the power head cord and plug the two
ends into each other. Next, insert the extension cord into
the cord retainer housing from the side. Loop the extension
cord around the retainer so it rests in the cord retainer.
Figure H

Blower operation

 CAUTION:
Always wear safety glasses.
Wear a filter mask if the operation is dusty. Use
of gloves, long pants and substantial footwear is
recommended. Keep long hair and loose clothing
away from openings and moving parts. THIS BLOWER
IS FOR HOUSEHOLD USE ONLY.

CAUTION:
Ensure the blower is switched
off and disconnected from the power supply before
attaching or removing the blower tubes. The blower
tube must be assembled to the housing before use.
• Hold the blower with both hands as shown in figure
I and sweep from side to side with the nozzle several
inches above the surface. Slowly advance keeping the
accumulated pile of debris in front of you.
Figure I

Vacuum operation


CAUTION:
Ensure the vacuum is switched
off and disconnected from the power supply before
attaching or removing the vacuum tube. The vacuum
tube and collection bag must be assembled to the
housing before use in vacuum mode.
• Position the vacuum tube slightly above the debris/
leaves. Turn the unit on, then using a side to side
sweeping motion the debris/leaves will be sucked up
the tube, mulched and deposited into the collection
bag (figure J) .
English
H1
H2
5