KEKAI OREGON Manual De Instrucciones página 30

ELECTRIC FIREPLACE INSTALLATION
NOTE
A 10 amp, 230 volt alternating current (VAC) circuit is required. A dedicated
circuit is preferred but not essential in all cases. A dedicated circuit will be
required if, after installation, the circuit breaker trips or fuse blows on a regular
basis when the heater is operating. Additional appliances on the same circuit
may exceed the current rating of the circuit breaker.
WARNING
Ensure the power cord is not installed so that it is pinched or against a sharp
edge and ensure that the power cord is stored or secured to avoid tripping or
snagging to reduce the risk of fire, electric shock or injury to
persons.Construction and electrical outlet wiring must comply with local
building codes and other applicable regulations to reduce the risk of fire,
electric shock and injury to persons. Do not attempt to wire your own new
outlets or circuits. To reduce the risk of fire, electric shock or injury to persons,
always use a licensed electrician.
PREPARATION
This product includes a GLASS panel! Always use
extreme caution when handing glass. Failure to do so
could result in personal injury or property damage.
Remove all parts and hardware from the carton and place them on a clean,
soft, dry surface. Parts and assembly steps are grounded for wall-hanging or
recessing use. Check the parts list to make sure nothing is missing. Dispose
of packaging materials properly. Please recycle whenever possible. You will
need the following tools
(not included): Phillips screwdriver; stud finder; level; tape measure; electric
drill; 1/4" wood drill bit, hammer.