Dip Switch Functions - TOSHIBA TEC Corporation B-450-QP Serie Manual De Instrucciones

4. DIP SWITCH FUNCTIONS

4. DIP SWITCH FUNCTIONS
The DIP switches are located at the rear of the printer.
WARNING!
Turn the POWER OFF before
changing the DIP switches.
DIP SW
No. ON/OFF
1
1 OFF OFF
ON OFF
2 OFF ON
ON
ON
OFF
3
ON
OFF
4
ON
OFF
5
ON
6
OFF
OFF
6
OFF
ON
ON
OFF
7
ON ON
8
OFF
ON
NOTES: 1. DIP Switch settings are read at power on time.
2. To enter the program download mode first set DIP SW #8 to ON. The printer will then enter
the relevant modes, as selected by DIP SWS #6 and #7. To initialise these modes hold
down the [FEED] or [FEED] and [PAUSE] keys whilst turning the power on. If the printer
is turned on without pressing a key, it will enter the program download mode.
Do not set the switches to the maintenance mode as this may cause a failure.
3. When DIP SW#8 is set to OFF, the backing paper thickness setting can be changed by the
following combination of DIPSWs #6 and #7.
No.6
OFF
ON
All manuals and user guides at all-guides.com
DIP SW
Function
2
2400 bps
4800 bps
9600 bps
19200 bps
None
EVEN
Not available
Available
Available
Not available
7
RAM clear mode (Maintenance counter)
Threshold manual setting mode
Sensor adjustment mode
RAM clear mode (Parameter)
Normal operation mode
Program down load operation
No.7 Thickness of Backing Paper
OFF 70µm Thin Backing Paper
OFF 80µm Thick Backing Paper
E4-1
ENGLISH VERSION EO1-33005
4. DIP SWITCH FUNCTIONS
Fig. 4-1
Remarks
Transmission speed
(Baud rate)
Parity
Stacker
Auto media feed
Selectable only when
DIP SW #8 is ON.
Operating mode