Leap PQ9907S Manual De Instrucciones página 4

2) Parameters setting:
After starting up, before start timing (or pause), long press key for 2
seconds to enter setting mode.
Note: During operation, long press for 2 seconds to enter setting
mode, the time will be automatically paused, and the modified parameters will
only be temporary modified, after shutdown and boot again, it will back to the
default setting of parameters.
2.1, Count up timing setting:
Under the initial screen (0:00 00) state or when the time is set to 0, it defaults
to count up timing mode, only need to set the alarm on or off. The setting
screen for "bonus" or "delay" will not display.
2.2, Count down timing setting:
After entering the setting mode, "Hour" value on the left will start flashing. Each
press for【+】 or 【-】 key, the hour value will increase or decrease by 1, press
key to switch next value, digital numbers flashing in turn: hour→
minute→ bonus→ delay→ alarm cycle switch, use 【+】 and 【-】 key to adjust
the parameters.
Maximum time setting value: 9 hours 59 minutes 59 seconds. When switch to
the "hour" value on the right, it will synchronized the parameters set on the left
before automatically. For setting different parameters on the right, you can
press again to switch the value.
2.3, Set bonus time:
When the right countdown timing finish setting, switch enter the "bonus time"