Audizio Trento Manual De Instrucciones página 10

Before transmission between your BT device and the radio is possible, both devices must be coupled. This process is called
"pairing". The radio is served as a receiver, to receive music stream to play on the radio.
If you have already coupled to a BT device before, this connection will be restored automatically when both devices are in
range and BT operation has been selected on the radio. "Pairing" does not have to be repeated. This function
may need to be activated on your BT device, however.
•
Push the Menu button to display the selection menu for the different operating modes.
•
Use the up/down button to select the operating mode BT and push the dial switch.
•
Switch on your BT device to which you want to connect the radio to and activate the pairing mode. The device scans
for BT devices within the reception range.
•
When the radio is found, your BT device shows its name Audizio Trento.
•
Select the radio on your BT device.
•
Start playback on your BT device.
•
Playback now takes place using the radio.
•
Choose Alarm from the main menu or press the <Alarm> button on the remote control.
•
Select either Alarm 1 or Alarm 2, choose Turn on to activate the Alarm.
•
Follow the alarm wizard instructions to set the alarm.
•
The wizard will guide you through the settings below:
Time - Set the time for the alarm.
Sound - You can choose Wake to Tone, My Favourite, Wake to FM Radio or Wake to DAB Radio as the alarm source.
Note - Wake to FM or Wake to DAB Radio - only the preset stations can be used for the radio alarm (if the
preset scan has been completed).
Wake to My Favourite - Please preset your favorite station before setting this as the alarm source.
Repeat - You can schedule the alarm as you desire -Everyday, Once or multiple days.
Alarm Volume - Adjust the volume of the alarm as you like by rotating the <Tune/Select> knob or <Cursor
up/down> buttons on remote.
Alarm duration - Set the duration of the alarm from the preset options ranging from 30 to 180 minutes. The radio
will be turned to standby when the selected duration of time is due.
•
After the above settings are completed, press the <Cursor left> button to exit and make sure the Alarm is turned on.
You will see the Alarm icon appeared on the display if it is activated.
You can set the timer force the radio in standby mode after the selected time has elapsed (within the range of 15 minutes to
180 minutes). Press the <Sleep timer> button on the remote control to set the timer. You will see the icon appearing on the
display when the timer is set.
10