Radio Frequency Emissions Limits In The Usa - Tait AXIOM WEARABLE Guia De Inicio Rapido

Radio frequency emissions limits in the USA

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cau undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Radio frequency emissions limits in Canada
This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS
Operation is subject to the
must accept any interference,in cluding interference that may cause undesired operation of the device.
EMC regulatory compliance in Australia and New Zealand
This product meets all ACMA and MBIE regulatory requirements for electromagnetic compatibility
(EMC). For more information about EMC compliance, visit the ACMA website at www.acma.gov.au
and the MBIE website at www.mbie.co.nz.
Europe and the UK
Intended purpose of product
This product is a broadband communication device. It is intended for radiocommunication services, to be
used in the UK, in all member states of the European Union (EU), and states within the European Economic
Area (EEA).
Tait International Ltd - November 2021
following two conditions: (1) this device may not cause interference, and (2) this
standard (s).
device
6