While Operating; Maintenance And Storage - Toro ProLine 21 Recycler II 22031 Manual Del Operador

While Operating

1. Do not run engine indoors.
2. Always maintain secure footing. Keep a firm
grip on the handle and walk; never run. Never
operate mower in wet grass. Mow only in
daylight or in good artificial light.
3. Mow across the face of slopes; never up and
down. Use extreme caution when changing
direction on slopes. Do not mow excessively
steep slopes.
4. Keep face, hands, and feet away from the mower
housing and cutter blade when the engine is
running. Stay behind the handle until the engine
stops and keep clear of discharge opening at all
times.
5. When cutting and re-cutting grass clippings,
remove grass bag and ensure discharge tunnel
plug is locked securely in place. When bagging
grass, stop engine and ensure discharge tunnel
door is closed before the bag is removed and
emptied.
6. Shut engine off and wait for all moving parts to
stop before unclogging discharge tunnel. Use a
stick, not your hand, to unclog tunnel.
7. Since the blade rotates for a few seconds after
the engine is stopped, stay behind the handle
until all moving parts stop.
8. After striking a foreign object or if mower
vibrates abnormally, stop engine and remove
wire from spark plug. Check mower for damage
and make all repairs before using mower again.
9. Shut off engine and wait for all moving parts to
stop before adjusting the height–of–cut.
10. Stop the engine when crossing a gravel
driveway, road or sidewalk.
11. Stop engine before leaving the operator's
position—behind the handle. Disconnect wire
from spark plug if mower will be unattended.
EN–3
12. Do not touch engine while it is running or
shortly after it is stopped because engine will be
hot enough to cause a burn.
13. Refuel only when engine is cool.

Maintenance And Storage

1. Perform only those maintenance instructions
described in this manual. If major repairs are
ever needed or if assistance is desired, contact
your local Authorized TORO Service Dealer.
2. Before mower is cleaned, inspected, serviced, or
adjusted, stop engine and disconnect wire from
spark plug. Keep wire away from plug to prevent
accidental starting.
3. To ensure the mower is in safe operating
condition, frequently check and keep all nuts,
bolts, and screws tight. Ensure blade bolt is
tightened to 50 ft–lb (68 N m).
4. To reduce fire hazard, keep engine free of
excessive grease, grass, leaves, and accumulation
of dirt.
5. Check grass catcher bag frequently for wear or
deterioration. Replace with a new bag for your
protection.
6. Allow engine to cool before storing mower in
any enclosure. Do not store mower near any
open flame or where gasoline fumes may be
ignited by a spark.
7. Do not overspeed the engine by changing
governor settings.
8. At the time of manufacture, the mower
conformed to the safety standards in effect for
rotary mowers. To assure best performance and
continued safety certification of the mower, use
genuine TORO replacement parts and
accessories. Replacement parts and accessories
made by other manufacturers may result in
non–conformance with the safety standards, and
that could be dangerous.