Troubleshooting - Husky HU80709A Manual Del Operador

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Engine fails to start
Engine hard to start
Engine lacks power
Detergent fails to mix with spray
Pump doesn't produce pressure
Machine doesn't reach high
pressure

TROUBLESHOOTING

CAUSE
No fuel in tank
Spark plug shorted or fouled
Spark plug is broken (cracked
porcelain or electrodes broken)
Ignition lead wire shorted, broken, or
disconnected from spark plug
Ignition inoperative
Water pressure built up in machine
Water in gasoline
Weak spark at spark plug
Dirty air filter
Detergent injection hose is not properly
submerged
High pressure nozzle attached
Low pressure nozzle installed
Inadequate water supply
Trigger handle or spray wand leaks
Nozzle is clogged
Pump is faulty
Air in line
Inlet filter clogged
Diameter of garden hose is too small
Water supply is restricted
Not enough inlet water
Wrong nozzle is attached
15 — English
SOLUTION
Fill tank
Replace spark plug
Replace spark plug
Replace lead wire or attach to spark plug
Contact authorized service center
Squeeze trigger to release pressure
Drain entire system and refill with fresh
fuel
Contact authorized service center
Clean or replace air filter
Insert injection hose into detergent
container or detergent bottle
Use Soap Blaster nozzle to apply
™
detergent
Replace with high pressure nozzle
Provide adequate water flow
Check connections and/or replace trigger
handle or spray wand
Clean nozzle
Contact authorized service center
Squeeze trigger on trigger handle to remove
air from line
Remove filter, rinse clean and reinstall
Replace with 3/4 in. garden hose
Check garden hose for kinks, leaks, and
blockages
Open water source full force
Attach the high pressure nozzle