Assembly - Triton BRA 200 Instrucciones De Funcionamiento

e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power
tool's operation. If damaged, have the power tool
repaired before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.

ASSEMBLY

Unfold the quadrants from behind the Work Panel (A).
Fasten the Rear Track Arm (C) to the Rear Quadrant and
the Front Track Arm (B) to the Front Quadrant using the
fasteners D and E, F and G as shown in Fig. 1. Do not
over-tighten the pivot bolts (D) as the quadrants must be
free to pivot smoothly.
D
Fitting to the Workcentre
Unplug the saw, and make sure the switch is 'Off'.
Remove the rip fence and overhead guard, but leave the
overhead guard support in place. Make sure the saw blade
is at full height, and that the saw
chassis is securely locked under
the table.
Set the Bevel Ripping Guide at
90° and insert it into the fence
tracks from the left, as shown
in Fig 2.
Fix the Bridge (H) into the saw
slot approximately 10mm (
shown in Fig.2. When the bevel ripping guide is not in use,
the bridge can be stored in the top slot of the workpanel,
Loosen the four countersunk screws at the base of
the Work Panel (A) and position the front edge support
approximately 5mm ( ⁄ ") in front of the saw blade. Position
1
5
the rear edge support so that the smaller section fits
between the saw blade and the overhead guard support.
Reposition the guard support if necessary. Tighten the
screws to secure the edge supports.
Slide the Bevel Ripping Guide in (still set at 90°) until it
touches the saw blade, front and rear.
E
G
Fig.2
⁄ ") in front of the saw blade as
3
8
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
J
A
I
F
C
Check whether you have identical scale readings on the
front and rear track arms, ie. that the guide is exactly
parallel to the blade and to the Workcentre table. The
readings do not necessarily have to be '0', but they
should be the same or similar. A variation of 1mm (
acceptable.
If your variation is more than 1mm (
a little and try again. A minor flatness problem with your
saw blade can translate into a significant mis-match in
scale readings.
Check whether any mis-match is due to slight sidewards
play at the back of your blade, and check whether your
saw is correctly mounted on the slide chassis.
Storage note: The track arms must be set at 90° for the
quadrants to be folded behind the work panel for compact
storage.
• Most bevel angles can be cut with the overhead guard
in place. If you remove the guard for a specific cut,
take great care and replace the overhead guard before
continuing with other cuts.
• Keep fingers completely clear of the blade, including
the area behind the workpiece close to the blade.
• Take care when handling workpieces and off-cuts,
bevel cuts can result in sharp edges.
Safety Instructions / Assembly
H
⁄ "), turn the blade
1
32
B
⁄ ") is
1
32
GB
5