Pressure W Asher Maintenance - Craftsman 580.752990 Instrucciones De Uso

OWNER'SRESPONSiBiLiTiES
Follow the hourly or calendar intervals, whichever occurs
first. More frequent service is required when operating in
adverse conditions noted below.
ii@iii iiii i iiiiiiii iiiiiiiiiiii iiiii
• Changeengine oil
iiiiiiiiii iiiiiiiiiiiiiiiiiiiiiiiiii iii;i !i_ ilil _ ii _ai!! ii J_iii i _ _ il iiii i !iiiiii_i
• Check/clean water inlet screen'
• Check high pressure hose
• Check detergent siphoning tube
• Check spray gun and assembly for leaks
• Cleandebris
• Check engine oil level
• Cleanengine air cleaner and pre-cleaner2
• Changeengine oil2
• inspect muffler and spark arrester
iiiiiii iiiiii i ii i iiiiiiiii_iii i iii _ iiii i ii:ii iiiii_iiiii i _! _ iii_ _ i _ ii iiiiiiii i i iiii iiiiii iiii iiiiii iiii iiiiii iiii iiiiii iiii iiiiii iiii iiiiii iiii iiiiii iiii iiiiii iiii iiiiii iiii iiiiii iiii ii
• Service spark plug
• Replace engine air cleaner and pre-cleaner2
• Cleancooling system_
_iiiiiiiiiiiiiiiiii iiiiiii i_i!i!iiii iii;i_i_i_i_i i iiiii_ iii iii_iiiiii_iiiiiil i i_iiiii _i i ii_iiiiii iiiiiiiiiiiiiiii iiiiii iiii iiiiii iiii iiiiii iiii iiiiii iiii iiiiii iiii iiiiii iiii iiiiii iiii iiiiii iiii iiiiii iiii iiiiii
• Changepump oiP
EmissionsControl
Maintenance, replacement, or repair of the emissions
controldevices and systemsmay be performed by any non-
road engine repair establishment or individual. However,
to obtain "no charge" emissions control service, the work
must be performed by a factory authorized dealer. Seethe
Emissions Warranty.
BeforeEachUse
1. Checkengine oil level.
2. Cleandebris.
3. Checkwater inlet screen for damage.
4. Checkhigh pressure hose for leaks.
5. Checkgun and nozzle extension assembly for leaks.
6. Purge pump of air and contaminants.
PRESSURE W ASHER MAINTENANCE
Clean Debris
Daily or before use, clean accumulated debris from pressure
washer. Keeplinkage, spring and controls clean. Keep area
around and behind muffler free from any combustible debris.
inspect cooling air slots and openings on the pressure
washer. These openings must be kept clean and
unobstructed.
Pressure washer parts should be kept clean to reduce the
risk of overheating and ignition of accumulated debris.
• Use a damp cloth to wipe exterior surfaces clean.
NOTICE improper treatment of pressure washer could
damage it and shorten its life.
• DONOTinsertanyobjectsthroughcoolingslots.
Clean if clogged. Replace if perforated or torn.
2 Service more often under dirty or dusty conditions.
3Change after first 50 hours of operation and then every 200 hours or 3 months,
whichever occurs first.
GeneralRecommendations
Regular maintenance will improve the performance and
extend the life of the pressure washer. See any Sears or
other qualified service dealer for service.
The pressure washer warranty does not cover items that
have been subjected to operator abuse or negligence. To
receive full value from the warranty, the operator must
maintain pressure washer as instructed in this manual
including proper storage as detailed in Storage.
Some adjustments will need to be made periodically to
properly maintain your pressure washer.
All service and adjustments should be made at least once
each season. Follow the requirements in the Maintenance
Schedule chart above.
NOTICE Oncea year you should clean or replace the spark
plug and replace the air filter. A new spark plug and clean air
filter assure proper fuel-air mixture and help your engine run
better and last longer.
• Use a soft bristle brush to loosen caked on dirt, oil, etc.
• Use a vacuum cleaner to pick up loose dirt and debris.
Checkand Clean inlet Screen
Examinegarden hose inlet screen. Cleanif it is clogged or
replace if it is torn.
CheckHigh Pressure Hose
High pressure hoses can develop leaks from wear, kinking,
or abuse, inspect hose before each use. Check for cuts,
leaks, abrasions, bulging of cover, or damage or movement
of couplings. If any of these conditions exist, replace hose
immediately.
_i_ WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
, NEVER repairhigh pressure hose.Replace it.
• Replacement hoseratingMUSTequalor exceed maximum
pressure ratingof unit.
17